Recent content by marjan

Ok, thanks for help, my intention is to be back on cycle as soon as possible, so i think I would do bloodwork and then decide would I go with pct or just wait few more weeks with recovery.

Hey guys, I would like to hear your opinions on this issue, few infos first, long time juicer, 15 cycles under my belt,every cycle done with proper PCT. Now, I was off with ass about 1 year(bloodwork done after 11 months of not jucing, evrything was ok), then I started test e only cycle...

Can a water based winstrol be injected with insulin syringe under the skin(the same way as you would injected HGH or HCG)?

thanks bro for the help

Ok bros, I will be doing this cycle 1-5 dbol 40mg/day 1-15 boldenon 600mg week 1-15 test e 500mg week 6-12 tren a 100mg EOD 8-15 winstrol tabs 60mg/day I already have plans what kind of PCT should I do but would like to hear suggestions

Did anybody used this int.lab, any info about resultats with it, thanks.

is it ok to hold preloaded hcg in deep fridge??

is it a stupid Q? come on people :Chef:

I am starting a cycle after long time I was off,I will use turinabol(60mg/day-never used it before) for 6 weeks and test e(500mg week) for 10 weeks,I would like to know is turinabol kick in time the same as is with d-bol or anadrol with this two I would notice strenght and gains in 3-4 days, is...

home alone :)

I am going to throw away gear and in that way it will be 100% sterile for me. :mix:

I some of you guys can tell me if I did this good, I decide to bake the gear with the vial,I placed the gear and vial in owen and baked it on 200 degrees for 40 min,stick open pin in stooper for ventil,the only thing that woories me that stopper started to smell,do you think that gear is sterile...

Yes I know for the future, but what to do with this can I save it?

Hey bro I placed the vial with gear inside and stopper has started to melt down(the hole where I stick pin started to became bigger and bigger),what did I do wrong? :worried: :worried:

OK, so I stick a pin in a stopper, place the vial with gear inside in oven for 30 minutes at 220 degrees,but will the stopper melt down at 220 degrees?