GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Question
|
| Author | Topic: Question | ||
|
Novice 
Posts: 3 |
A friend of mine just bought a load of 3/4" pins. Was that a waste? I was told 1" minimum. He thinks being skinny, the 3/4" will be ok. all help appreciated. Esq.     | ||
|
Amateur Bodybuilder 
Posts: 57 |
I use a minimum of 1 inch even when injecting to delts..What guage did he buy and what kind of gear is going into the syringe???....Bam Bam | ||
|
Novice
Posts: 3 |
22 gauge for Test Cyp and Deca | ||
|
Amateur Bodybuilder
Posts: 57 |
I would say its definately to small especially for glutes and quad shots..get at least one inch..Bam Bam | ||
|
Pro Bodybuilder 
Posts: 377 |
does sound a bit small. i like 1' 23g myself ------------------ | ||
|
Cool Novice 
Posts: 49 |
Just be sure to hit an area with thin skin. Deffinatly not the glutes! When the pin is in put a little extra pressure on it to push it a little deeper into the muscle. | ||
|
Amateur Bodybuilder
Posts: 265 |
If you Inject it in Quads, you should'nt have any problem with it. I do my Sust injections in Quads with 1", 20gauge pins... no problem at all. [This message has been edited by Androl (edited September 11, 2000).] |
All times are ET (US) | |
 |
|
|
posted September 11, 2000 12:37 AM