GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Look before you stick!!!!
|
| Author | Topic: Look before you stick!!!! |
|
cm3504jm Pro Bodybuilder (Total posts: 154) |
posted August 04, 2000 11:03 AM
  
Helpful hint for safety's sake. Look at the syringe before you inject. Hold it up to the light. I did this last night and found some of the rubber stopper had been sucked into the syringe through the drawing needle. Not good to inject rubber particles into your muscle. I had a few filters on hand and used one on my injection last night. I think everyone should have some filters on hand to deal with such a situation. Its hard enough to take extra precautions to be sterile. Look at what you are putting into your body. Thanks ------------------ IP: Logged |
|
Future One Pro Bodybuilder (Total posts: 126) |
posted August 04, 2000 09:16 PM
what are these filters? and where do you get them?? IP: Logged |
|
CraZyWhiTe Amateur Bodybuilder (Total posts: 31) |
posted August 04, 2000 09:19 PM
I keep 1 old pin around just for extarcting the sauce.. then break out a brand new tip when im ready to inject just to make sure its as sharp as possible.. and no rubber .. inside Just my .02 ------------------ -Big poppa Pump IP: Logged |
|
ripp Pro Bodybuilder (Total posts: 231) |
posted August 04, 2000 09:24 PM
this is called "coring". Insert the needle at a 45 degree angle with the hole pointing upwards. This will prevent any possible coring of the stopper. Coring is common with larger diameter needles. IP: Logged |
All times are ET (US) | |
 |
|
|