GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Injection problem- please help
|
| Author | Topic: Injection problem- please help |
|
TooJacked Amateur Bodybuilder (Total posts: 15) |
posted May 04, 2000 04:37 PM
  
I have a quick question, shouldn't be too hard to answer. Im going to be injecting 750mg sus. How should i go about drawing the juice out of the three amps. I would think to put it all in the same syringe, but im not sure. Thanks for the help IP: Logged |
|
matty Pro Bodybuilder (Total posts: 443) |
posted May 04, 2000 05:08 PM
i would draw it all into 1 3cc syringe and inject half into each glute! or you could inject all 3ccs into 1 glute its up to you... ------------------ IP: Logged |
|
Ice Man Pro Bodybuilder (Total posts: 217) |
posted May 05, 2000 09:48 AM
Remember to switch pins. Don't risk infection. IP: Logged |
|
TooJacked Amateur Bodybuilder (Total posts: 15) |
posted May 05, 2000 09:17 PM
So I should basically crack open all three amps and se the same the needle to draw it up from all three, then switch to a different pin to inject? IP: Logged |
|
AY Amateur Bodybuilder (Total posts: 51) |
posted May 05, 2000 10:57 PM
Yes, different pins for drawing and injecting. Also, if you're injecting in both glutes, then change the pins, too. It's better safe than sorry. AY IP: Logged |
|
alwaysniceguy Amateur Bodybuilder (Total posts: 36) |
posted May 05, 2000 11:03 PM
with that much at one time, your gonna be sore when that prop. crystalizes. can u say, "RUB-A-DUB-DUB?" and then RUB even more. help it to dissapate. NICE IP: Logged |
All times are ET (US) | |
 |
|
|