GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
 UBBFriend: Email This Page to Someone! |
 George Spellwin's ELITE FITNESS Discussion Boards
 Anabolic Discussion Board
 Problems!
|
| Author | Topic: Problems! |
|
SynWiz Amateur Bodybuilder (Total posts: 7) |
posted April 03, 2000 11:04 AM
  
I am currently on a cycle of suspension and V, my problem is that I am having a hard time getting the suspension out of the 20ml vile. I am using 1.5in/22G pins and I still have the hardest tiem getting a really good load. Any suggestions? IP: Logged |
|
ANVIL 2 Amateur Bodybuilder (Total posts: 49) |
posted April 03, 2000 11:27 AM
SHAKE UP THE TEST. TO MIX UP THE SOLUTION. TRY USING A LARGER GAUGE NEEDLE TO WITHDRAW AND REPLACE WITH THE 22G TO INJECT. IP: Logged |
|
macrophage69alpha Moderator (Total posts: 1112) |
posted April 03, 2000 01:22 PM
heat up the solution by placing in partially submersing in HOT water then shake well and draw you should have no problem then ------------------ IP: Logged |
|
Mlrtime1 Amateur Bodybuilder (Total posts: 20) |
posted April 03, 2000 10:03 PM
You could try pumping some air into the bottle with a syringe. This will also make it easier. IP: Logged |
|
deltman Pro Bodybuilder (Total posts: 146) |
posted April 03, 2000 10:16 PM
Yes, the air creates pressure within the bottle. Heat it up as well. deltman IP: Logged |
All times are ET (US) | |
 |
|
|