GEORGE SPELLWIN'S ANNOUNCEMENTS
Enlightening Men about Anabolic Steroids and Bodybuilding for over Two Decades
|
 Elite Fitness Bodybuilding, Anabolics, Diet, Life Extension, Wellness, Supplements, and Training Boards
 Anabolic Discussion Board
 Rubber in the syringe. What to do?
|
| Author | Topic: Rubber in the syringe. What to do? | ||
|
Elite Bodybuilder 
Posts: 1023 |
There is a little peice of the stopper in the syrige now after drawing from the vial. I don't wnat to waste all this juice(3cc's worth) but I don't want to inject it. What to do??? ------------------     | ||
|
Pro Bodybuilder 
Posts: 409 |
Is it in the syringe or in the needle? How is it possible? Maybe it would be better just to push the juice back into the vial and try again? | ||
|
Pro Bodybuilder
Posts: 542 |
Don't understand how that happen, but like Retabolil2 said try pushing it back in the vial, then get another dart and try again. | ||
|
Elite Bodybuilder
Posts: 1023 |
It came from the stopper. Enough jabs into a vial with an 18g drawing pin and you are bound to loosen some rubber up somewhere. ------------------ | ||
|
Elite Bodybuilder
Posts: 1023 |
upity | ||
|
Pro Bodybuilder
Posts: 542 |
If you can get another Vial, and transfer your A.S to the new Vial. | ||
|
Freak 
Posts: 1676 |
If it's in the needle, then changing needles or if it is a rediject remove the plunger and shake it into another syringe. If in the syringe reshoot it in another one use a very small needle. I would not waste the 3 cc's. ------------------ Don't look back, life is too short | ||
|
Elite Bodybuilder
Posts: 1023 |
Bump...I would hate to waste the holy water. Throwing it away and not making use of good gear would absolutely crush my heart. |
All times are ET (US) | |
 |
|
|
posted January 15, 2001 10:35 AM