Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

why the hell do AAS labs use ampules?

elgenyo

New member
I'm trying to find logic in this. They shatter if not handled delicately. You always run the chance of injecting tiny shards unless you use a whatman and if you do you lose some of the juice in the filter. So why are these things even made?
 
AAS labs?

Most ampules I've come across are HG gear. I'd rather have HG ampules than shitty UG bathtub gear in multi use vials.
 
well sure but there are plenty of hg un multi use vials to. thise amps are a pain in the ass.
 
It's really good for accurate dosing. Only an idiot would screw up drawing 1ml from a vial, but 1/2 the world is below the average intelligence, so there are idiots out there.


Using a proper ampule opener rids almost all the risk of getting anything in the oil.
 
Last edited:
I eat the empty amp when I'm done injecting. I used to shatter it and lick the inside of the glass, but eating it is easier. Gotta make sure I get all that test!
 
I found that when you have a 10 cc bottle by the time you get to the end your short 1/2 to 3/4 short.So when you have amps you know what you have.My thoughts.
Silent
 
There is a way to open them to avoid not getting a clean break. Ever notice amps all have a little dot on them? That's there to tell you what side you're supposed to put pressure on to break the neck.
 
damn foreigners... american companies like watson use 10ml vials ...

also if you have a script... compound pharms use vials too
 
...

Using a proper ampule opener rids almost all the risk of getting anything in the oil.

I don't know about that. I would think that very tiny shards of glass are almost always going to be present to some degree or another. Or, at least it's still a possibility.

I remember my first cycle was based around sust and they were never quite a mL, more like 3/4 or somewhere around that. And, believe me, I was careful to really try to get everything out of the amp.
 
There is a way to open them to avoid not getting a clean break. Ever notice amps all have a little dot on them? That's there to tell you what side you're supposed to put pressure on to break the neck.


hmm...never really took notice. Thx for the heads up.
 
Top Bottom