Please Scroll Down to See Forums Below
why boil gear?
- Thread starter Sirius
- Start date
ive searched every article i could find on this recently. Boiling gear is supposed to help cut down on the Benzyl alcohol (BA). Also you can bake it, some say it works, some say it doesnt. Pretty much the reason for doing this is to stop having painful injections.
The way to do it is to put a needle through the rubber stopper and into the free air in the top of the bottle for ventilation. Then boil water, hold the bottle in the boiling water for 5 to 10 minutes. Ive also heard of baking for 45 minutes at 250 degrees. I personally just tried it and didnt think much of it, now im just cutting my stuff with injection oil to kill the pain.
The way to do it is to put a needle through the rubber stopper and into the free air in the top of the bottle for ventilation. Then boil water, hold the bottle in the boiling water for 5 to 10 minutes. Ive also heard of baking for 45 minutes at 250 degrees. I personally just tried it and didnt think much of it, now im just cutting my stuff with injection oil to kill the pain.
maxpayne72
New member
Agreed, except the boiling point of BA is much higher then the boiling point of water. (unlike other alcohols). So boiling doesn't work for lowering it. Boiling does work for sterilizing gear that may have been exposed to the air, as would happen during rebottling.
Also,the components of oils are usually the inert oil, the hormone powder, BA , and I can't remember the fourth thing.
I thought one was a perservative (the BA?) and the other helps with making the hormone soluable in the oil. So baking that out may cause the test(powder) to precipitate.
BA is very toxic. But it is in very minute doses in oils.
Anyone know more about this?
Also,the components of oils are usually the inert oil, the hormone powder, BA , and I can't remember the fourth thing.
I thought one was a perservative (the BA?) and the other helps with making the hormone soluable in the oil. So baking that out may cause the test(powder) to precipitate.
BA is very toxic. But it is in very minute doses in oils.
Anyone know more about this?
viagraboy said:
i dont want to sound like a dick or anything, but what the fuck. how painful can your injections be? where are you jabbing yourself to actually make it that miserable that you want to find ways to lessen the pain? ive done 3cc of test enanthate, 3cc of test cypionate, and 3cc of sustanon on different occaisons to my thigh and butt and the only thing that bothered me was the lump i had for almost a week. dont think this is a post trying to flame or anything, but i am honestly interested in why your injections are so uncomfortable.
D
drunk7daysaweek
Guest
it increases the alcohol content in it
shamrock11
New member
You need to be careful boiling gear you can change the structure of the gear you get and it may even effect how it reacts in your body.
spikemydog
New member
this must be a new trend i guess.never heard of boiling juice.ive heard of some heating it.... ive takin 18g 2cc of sust and walked it off in a few days.i feal the pain is there for a reminder to lift harded and stay disipline.... not to jest just me
mustang_00
Well-known member
with underground gear you really (depending on who you get it from) have no idea how much of what went into making it so if you were to bake it and for some strange reason the compounds crash, when you inject it's going to hurt a hell of a lot worse than prop!! just becareful
marshallmadman
New member
I would recommend just cutting your gear with a little sterile oil. Or perhaps get some low dose EQ or Deca to cut with.
