which oil is lighter tren or Test E?

[shrimp44]

I loaded my syringe with 1cc of Tren A, and 1cc of Test E
I did a GLute shot with "1 1/2" inch syringe, after i injected i held it there for 30 seconds to make sure none would leak out after...

sure enough when i pulled out a few driplets of oil caming out maybe about .25-.5 of a CC...

I was wondering when you inject Test E and Tren A which one goes in first the tren or the Test, I'm not sure which of the two is a lighter oil.

I'm hoping the Test E leaked out because the Tren is more important in my cycle right now....

 

[mr.nitro]

tren is gerenally thinner than test for some reason.

when I draw both into one syringe, ill shake it up to make sure its mixed together well.

 

[Dino Strong]

I loaded my syringe with 1cc of Tren A, and 1cc of Test E
I did a GLute shot with "1 1/2" inch syringe, after i injected i held it there for 30 seconds to make sure none would leak out after...

sure enough when i pulled out a few driplets of oil caming out maybe about .25-.5 of a CC...

I was wondering when you inject Test E and Tren A which one goes in first the tren or the Test, I'm not sure which of the two is a lighter oil.

I'm hoping the Test E leaked out because the Tren is more important in my cycle right now....

First it really depends on what oil is each injectable as to which oil is lighter or thinner. Even different types of oils will mix with each other in the syringe. U are almost acting like one oil is behaving like oil and water. This is not the case and diff. oils will mix.

Assuming the oil is the same, the tren A will be "thinner" in regards to its viscosity moving through the syringe. This however has nothing to do with the oil but rather the amount of mgs per cc of oil. The tren will move more easy through the needle because it is less concentrated at 75-100mgs per cc rather than 200+ mgs of test e per unit.

Hope this helps