Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

What size pin with Test E

I use a 20 gauge to draw then change needles to inject.

I pin the glutes w/ 1.5 inch 23 gauge, Bi’s and Delts get a 1 inch 25 gauge.

If you still have problems run your syringe under hot water for a bit prior to injecting.
 
I heated up the oil in the amp first and then again in the syringe. Completed my first injection succesfully although it was a very slooowww getting all that oil through a 25g needle.

Thanks alot for your help.
 
Bourget said:
I heated up the oil in the amp first and then again in the syringe. Completed my first injection succesfully although it was a very slooowww getting all that oil through a 25g needle.

Thanks alot for your help.
i inject all my gear SLOW anyway, and i use 25G for all my gear. primo was a bit thick for 25but i still used it, my fucking fingers got tired long before the syringe was empty !!
 
Bourget said:
I heated up the oil in the amp first and then again in the syringe. Completed my first injection succesfully although it was a very slooowww getting all that oil through a 25g needle.

Thanks alot for your help.

I think this is a beter idea than heating the syringe up. The more you mess with the syringe the higher your chances are of making it non-sterile. I like to remove it from the pack, draw, replace the needle with a new one, and inject.
 
farmerjohn said:
The best is a 10 gauge pin, about 3" long........seems to do the trick just fine.

if it doesn't all leak back out the hole in your ass.
 
Top Bottom