Type of syringes for tren and test e?

[Oliol]

Hello all,

What kind of syringes do you guys use? I used 1,5 inch 22 gauge on my last cycle, the only ones they had left when I went to the pharmacy today was 1,5 inch 25 gauge, what do you guys think? Thanks

 

[bonacris]

I use 1 inch 25g for everything.

Sent from my GT-N7100 using EliteFitness

 

[RickRock13]

I use 22g to draw, and 25g 1.5" to inject with every oil

 

[Oliol]

I use 22g to draw, and 25g 1.5" to inject with every oil

This might be a dumb question, but what do you draw it up to the container in the syringe then change the needle of the syringe?

 

[WolfpackAlpha]

Hello all,

What kind of syringes do you guys use? I used 1,5 inch 22 gauge on my last cycle, the only ones they had left when I went to the pharmacy today was 1,5 inch 25 gauge, what do you guys think? Thanks

22s? that's almost a nail, stick to 25g my friend

 

[25homes]

Yea bigger gauge to draw goes lot faster then switch before you hit..25g be fine

 

[Oliol]

Does it matter if I use the same needle to draw with as I inject with?

 

[bonacris]

It can blunt the needle and can hurt a little bit more.

Sent from my GT-N7100 using EliteFitness

 

[Oliol]

I can just mix the test and tren in the same barrel right?

 

[bonacris]

Yep you can. But that means you have to pierce 2 rubber stoppers and then pin. That could hurt

Sent from my GT-N7100 using EliteFitness

 

[ALIN]

Hello all,

What kind of syringes do you guys use? I used 1,5 inch 22 gauge on my last cycle, the only ones they had left when I went to the pharmacy today was 1,5 inch 25 gauge, what do you guys think? Thanks

I have been using 25g 1.5" precision glides and love them. Painless!

 

[bonacris]

Pins are so cheap i don't know why you would reuse them.. A box of 100 cost about 7 euro

Sent from my GT-N7100 using EliteFitness

 

[Oliol]

I didnt mean reuse, I meant to use same pin I draw with as inject, but after learning you can blunt the pin I will change it before injection. Do you guys just wear plastic gloves and take it off and put on a new one?

 

[bonacris]

Have you done a cycle before? If not you shouldn't be messing with tren

Sent from my GT-N7100 using EliteFitness

 

[MaxxReps]

No need for plastic gloves. Wash your hands prior. The needles come in sealed packages. I just open the end of the package and screw the syringe on the needle while holding the package.

I've injected with the same needle after drawing and it is a bit more blunt but still not too bad. Something that someone else mentioned though that I admit I didn't think about was that the outside of the draw needle is exposed to the rubber stopper. If you didn't perfectly clean the top of the vial off really well with alcohol there is a chance for a bug to get on the needle and then end up in your body as its a deep injection.

Also, 25g goes pretty slow with oils which is good for injection but not so much for drawing. Its easier to draw using a higher gauge needle.