Please Scroll Down to See Forums Below
TTokkyo Nandrolona vials underfilled?
- Thread starter Furious1
- Start date
The Iron Game
New member
I have seen a lot of posts complaining lately about how there 10ml vial is underfilled or "appears" to be underfilled. It has probably been explained before but for some of those out there who dont understand the logic behind it do the following.
Prepare the following:
*A 2cc syringe, (should be capable of 2.5 cc's)
*A 21, 22, or 23 Gauge pin
*A glass half full of water
1. Put the pin on the syringe and remove the cap.
2. Place the pin in the water and pull back on the plunger until the syringe is full and cannot take anymore water.
3. Turn the syringe upside down so that the pin is facing the ceiling / roof.
4. Flick the tiny air bubble at the bottom so that it rises towards the pin.
5. Start pushing on the plunger until the air bubble is out and the water is at the 2 cc point (make sure you shoot it back into the cup.
6. Stop, you are now at the 2cc mark but if you examine you will discover there is actually 2.3cc's of liquid.
If you use a 5cc syringe then this would be 2.6 cc's.
Thus for example, say you were injecting winstrol at 200mgs all in one shot, apply it to oil based steroids as well but the total amount in the syringe will be slightly different. Well back to the winstrol, if the solution was 100mgs/cc and you thought you were injecting 200mgs in the 2cc's you would actually be injecting 230mgs. This does not seem too much in one shot but multiply it by10 and it works out to 300mgs wasted that you didnt realise.
Peace
IG's final thoughts, if you examine the syringes closely you will more than likely find more than 1cc in each syringe.
Prepare the following:
*A 2cc syringe, (should be capable of 2.5 cc's)
*A 21, 22, or 23 Gauge pin
*A glass half full of water
1. Put the pin on the syringe and remove the cap.
2. Place the pin in the water and pull back on the plunger until the syringe is full and cannot take anymore water.
3. Turn the syringe upside down so that the pin is facing the ceiling / roof.
4. Flick the tiny air bubble at the bottom so that it rises towards the pin.
5. Start pushing on the plunger until the air bubble is out and the water is at the 2 cc point (make sure you shoot it back into the cup.
6. Stop, you are now at the 2cc mark but if you examine you will discover there is actually 2.3cc's of liquid.
If you use a 5cc syringe then this would be 2.6 cc's.
Thus for example, say you were injecting winstrol at 200mgs all in one shot, apply it to oil based steroids as well but the total amount in the syringe will be slightly different. Well back to the winstrol, if the solution was 100mgs/cc and you thought you were injecting 200mgs in the 2cc's you would actually be injecting 230mgs. This does not seem too much in one shot but multiply it by10 and it works out to 300mgs wasted that you didnt realise.
Peace
IG's final thoughts, if you examine the syringes closely you will more than likely find more than 1cc in each syringe.
Furious1 said:
dude... that's not the best idea.
when preloading syringes by drawing immunizations from a multidraw vial, the most that the preloaded syringes can sit around is 12 hours (maybe 24 hours) and that's if they're refrigerated..
what makes you think that injectable AAS would be different?
to me preloading takes unnecessary risks at infection as syringes are not a completely sealed container and as such are not suitable to hold any substance meant to be injected for any period of time longer than a few hours.
not good.
as for the ttokkyo, yup.. they're sometimes under loaded.. i ordered two deca (one for me, one for my cousin) and one was almost a half inch (1-2 ccs) lower than the other....
guess which one my cousin got.
