tren won't go through prefilter...why?

[40butpumpin]

it's like it's completely stopped up...can't push anything through it...probably a dumb question...but hey

 

[40butpumpin]

bump, what's up with this prefilter?

 

[galaxy]

Put it in coffee filter and let sit overnight........... unless you want to sit there pushing on it for about 6hrs.

 

[DNIndustry]

You mean the coffee filter?
I heat it before I send it through.
I usually prefilter over night.

If you mean the whatman you have to much filler in there.
Heat it before hand

 

[Christianlifter]

I have had that problem after filtering too..try it through a 3cc syringe with the 18guage needle. This will create more pressure, but put it through slow....or it will be cloudy..and you will have to filter again.

God Bless

 

[Stillgoing]

2 thoughts bro:

1- make sure when you dissolve the pellets you give it atleast 24hrs or so for all filler to dissolve to the bottom.

2- heat it up first. Put the vial on the stove on lowest heat setting for 30min.

 

[DNIndustry]

Stillgoing.
I would use a pot of water about 1.5 inches deep as and heat that instead of right on the burner. Less of a direct heat.
Just a friendly suggestion.

 

[Big BX]

Just made some fina. Let it sit for 48 hours, pushed 100mls though in 25 mins and 2 filters. Nice and golden.

 

[Stillgoing]

Stillgoing.
I would use a pot of water about 1.5 inches deep as and heat that instead of right on the burner. Less of a direct heat.
Just a friendly suggestion.

Thats what I meant bro.....good clarification.....

 

[thate]

it's like it's completely stopped up...can't push anything through it...probably a dumb question...but hey

Looks like you are finally going the homeade route . I usually buy an extra filter or two for times like these, plus I like to double filter the tren. I make sure the solution is warm before I start filtering as it goes through much easier. Also, make sure all the gunk is at the bottom and not floating around the bottle. Let me know how it turns out.

 

[Only1eagle]

agree with all the above.

Personal twist:

I usually suck up everything i can and leave the filler and some oil in the bottom. Then i will coffee filter just that and run some clean oil thru the coffe filter to help it through. Usually work slike a charm.