Syno-conversion question

[jacshelb]

After you've done your initial kit conversion and extracted your prop., will you need to purchase another kit to make it injectable? Or can you just cook it on low heat until the prop dissolves into the oil?


Thanks,


Jacob

 

[colt1911]

Don't know what kit you have. Mine came with the oil/solvent solution. All I had to do was add the powder to it and nuke it for 30 seconds, then sterile filter it, then I baked it 250 degrees for 30 min for safety.

 

[jacshelb]

I don't have any kit yet. I plan on using the one that makes prop and not tne. I guess that answers my question, though. i.e. Even if the kit I get doesn't have the oil with it, doesn't sound like much work after it's already in powder form.

Thanks!

 

[c3bodybuilding]

Jac did you order D's solution for making your powder, and rinsing it? If not, and you used not kit, then you probably have tne powder.

Tell me more of what you used to turn it into powder, and then we can go from there. If you did use the solution when making the powder, then you could just order your own oil, filters, etc.. but D's solution is the best because it leaves you with pain free shots. I need more info though....

 

[jacshelb]

I'm with you C3. Like I say, haven't even started yet, but will use d's when/if I do this.

If I use d's kit and have the pure prop. powder, what is involved after that point? Why the filters if it is already prop powder?

Thanks again guys,

Jacob

 

[c3bodybuilding]

If you have pure prop powder with the estrogen rinsed away, then you need to order the ba and oil, sterile viles and syringe filters. You have to put the powder into an oil/ba solition and then filter it into sterile viles.

 

[colt1911]

reason for filters

I'm with you C3. Like I say, haven't even started yet, but will use d's when/if I do this.

If I use d's kit and have the pure prop. powder, what is involved after that point? Why the filters if it is already prop powder?

Thanks again guys,

Jacob

The reason for the filters is because the prop powder is not sterile and you couldn't safely inject the final solution unless it was sterile filtered first. There is/might be some small particles in the powder that you would not want in the final solution. Also in my oil/solvent solution there were some tiny floating things. D said not to worry since you will sterile filter them out anyway. He was right. My prop is crystal clear like lite colored apple juice. D's kit is so fn easy, I converted some for my friend because it is so damn fun making it. Pain from prop?, well I could honestly tell you that I could not tell that I even did any. NO Pain at all. Good luck.

 

[jacshelb]

Wow, great help guys! Much appreciated.


Jacob

 

[c3bodybuilding]

I'm with colt on this one. It was a very fun science experiment and 110% pain free.