syno conversion is done but am nervous as hell!!! help

[strength]

i used synokits.com's kit and did everthing exactly how the instructions said to do it. Everything looks good after filtering, but how the hell do i know at what point i took the estradiol out???? was it with the distilled water?? the ph was correct, the last step of letting the post filtered material in 2oz of methanol left a bunch of powedery/crystally stuff?? i put it all into the oil, was that right???

just need some reasurance before i shoot my homebrew

 

[V-SHAPE 2]

Damn I would be nervous also, how many grams of test prop did you get?

 

[strength]

only did 5 carts

so i have 10 grams of test prop

each 5 cart conversion takes about 3 days

 

[gilly6993]

Well, if you grow breasts it's a safe assumption you didn't get it out.....I'm sure if you followed directions you should be fine.....

 

[tee]

I never used that type of kit, but with A's kit, it says to only take out the crystals and leave the powder. The problem I had was that there was no difference in any of the stuff left after it dried from the methanol. I used it all and didn't have a problem.

 

[strength]

thats

the same problem i had, there was no difference with the stuff left over after the methanol evaporated. I think it was when u rinsed it in the coffee filter that it got rid of the estrogen.

 

[boss]

Well, if you grow breasts it's a safe assumption you didn't get it out.....I'm sure if you followed directions you should be fine.....

oh that one hurt...........hehehe

 

[strength]

bump

bump

 

[tee]

If you want a lot of good threads on the Synovex conversion, check out the fina board. They have a lot of good info over there.

http://pub24.ezboard.com/bfinaplix

 

[TrueCowboy]

Last step in directions per www.synokit.com:

Step 5 - Filter
Filter out the testosterone propionate
as described. Let the filter completely drain, then rinse with water. Repeat this rinsing 2 more times. Now you have pure testosterone propionate, allow it to dry and it is ready for processing.

2 oz methanol not mentioned in this step. Did you mistype?

To test for purity:
There are many ways to measure melting point, but an easy way to do it at home is to put some about oil in a pan on a stovetop burner. You will need an accurate thermometer, a test tube, and a few milligrams of your crystals. Be sure you can easily tell the difference between 115 C (239 F) and 120 C (248 F) degrees, this small difference is important! Turn on the burner and heat it to about 100 C (212 F). Make sure the temp is stable. Now put the crystals in the test tube and hold this in the oil, but do not let the test tube touch the bottom of the pan. Slowly increase the heat until the crystals melt, and note the temperature. When the crystals melt at 118 C - 120 C (244.4 F - 248 F), you have pure testosterone propionate. Ref: "The Synovex Solution" by Dazed

I did two seperate tests last night and resulted in 123C and 124C consecutively. This was done using TP from the formentioned kit. This leads me to believe that if the directions are followed properly, a highly pure product (free of estradiol) will result.