Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Suggestions please....

KayKo

New member
Hey all I posted a week or so ago in regards to redness and warmth around my delt injection site (gone now)....doing 1 gram of GTP test enanthate a week. Well I did my 2nd delt jab on Thursday and redness has come up on my other arm as well, but not on the injection site. It's more to the lower/upper arm area and the redness is probably around 5 inches diagonally.

People from the last post stated that GTP enanthate will do this at times, but as a precaution I was prescribed some keflex in case it is an infection. I'm about to start my third week of the cycle, but am now faced with whether I should continue or just stop and move on the PCT. The red area is warm and very firm to the touch...no lumps which is good I suppose as I believe that would be a sign of an absess. What do you all think I should do? I will be doing the quads this week, which when done the 1st week, were also in pain. Any suggestions will greatly be appreciated!!
 
didnt see ur other post....but....how are you dividing your mgs? 500mgs on monday and thursday? you arent injecting the gram on just one day right?
how sterile are you when it comes to injecting...?
 
Correct....500mgs on Monday and on Thursday.

When it comes to sterility, I am very cautious. I swab the top of the vial, the injections site pre-injection, and the injection site post-injection......each with new prep pads. Use different pins on drawing from the vial and injection. Hope that helps!!
 
Are you mixing the test with anything or just shooting it straight? And are you experiencing any pain or soreness post injection?
 
KayKo said:
Correct....500mgs on Monday and on Thursday.

When it comes to sterility, I am very cautious. I swab the top of the vial, the injections site pre-injection, and the injection site post-injection......each with new prep pads. Use different pins on drawing from the vial and injection. Hope that helps!!
well im not sure then...sounds like ur doing everything right to me...sometimes u just get bd injects
 
I'm doing straight test. A couple of the bro's have also noticed some pretty bad pain on the GTP enanthate as well.....maybe the BA concentration? Probably a couple of hours after the injection the soreness starts to kick in. I doubt it's bunk gear as the source is very reputable. Possibly a bad vial? I'm gonna see how the jab goes tomorrow and then go from there.
 
Top Bottom