So now what?

[TheGooch]

ok, call me ignorant but...

I am down in Zihua, Mexico for the next 3 months. I just did my last injection of 75mg Tren A/ 75mg Prop, and I'm ready for PCT.

I have Clomid and HCG, BUT:

The HCG comes in these little Ampules, and I know you mix the water with the powder. However:

1) Do I need another Vial to mix these 2 together? It looks like you have to brea off the glass tops or something? I'm new to this...what to do, what to do...

2) Should I run 100mg of Clomid for 30 days, or will 50 mg suffice? I weigh 210lbs, 35 years old, 6'2".

3) I have 1/2" insulin Pins, all I could find down here, but those should work, right

4) Should I stick intramuscular, or subcontaneous?

I REALLY NEED HELP ON HOW TO MIX THIS STUFF IN A STERILE WAY! It comes in 3 ampules of Water, and 3 ampules of Powder for a total of 5000iU's.

Help a brother out who's stuck deep in Mexico and has limited internet access!

Gracias!

 

[omega529]

1 Mic bac water in the vial with powder.
2 i personally tyhink 50mg is fine
3 for HCG, yes
4 I think either is fine, but i heard intramuscular can cause scar tissue....I usually do it intramuscular and havent notice any scar tissue though.

 

[Mac173]

This is how I do it:

(not sure how many iu's are in your amps)

I inject 1cc bac water into 5000iu HCG vial

Swirl to mix but usually dissolves on contact

Draw out HCG/bac solution and inject into sterile vial

I now have 5000iu/ml

Add 4 more cc's to sterile vial to give me 5ml=5000iu or 1000iu/ml.

This will allow me to inject 1/2cc @ 500iu/day

I use a slin pin in the delt.

 

[TheGooch]

This is how I do it:

(not sure how many iu's are in your amps)

I inject 1cc bac water into 5000iu HCG - human chorionic gonadotropin - vial

Swirl to mix but usually dissolves on contact

Draw out HCG/bac solution and inject into sterile vial

I now have 5000iu/ml

Add 4 more cc's to sterile vial to give me 5ml=5000iu or 1000iu/ml.

This will allow me to inject 1/2cc @ 500iu/day

I use a insulin pin in the delt.

ok sounds good, BUT:

call me stupid: do you "break off" the glass tops from the Amps? Do I need a seperate vial to mix?

Its all kinda confusing??

 

[s8nlilhlpr]

ok sounds good, BUT:

call me stupid: do you "break off" the glass tops from the Amps? Do I need a seperate vial to mix?

Its all kinda confusing??

yes, you have to break the top of the amp. score it around the thinner part near the middle/top with a sharp knife, then snap it off. If they BOTH (powder and saline) came in ampules then you will probably need a sterile vial. Only ones i've seen come with an amp of water, and a small vial of powder. Suck the water up, spray it down sides of vial (not directly on to powder) swirl to dissolve and suck it back up.

If you have to order a vial, you might as well pick up some Bac water on the same order, its better than the saline they come with.

 

[TheGooch]

ok, cool, that helped! I am sure I can get a sterile vial in the "pharmacia"...

I'll boogey over there now to check it out...Thanks!