Shooting fina everyday??

[goheavy63]

For you guys that shoot fina everyday where do you guys usually shoot it? What size pin do you use? I was planning on using my bi's some but would like someone with experience to tell me if its to much pain?

 

[nuh_mizer]

Everyday is a pain in the arse but I like it better that eod. I usually rotate between quads and gludes. Sometimes I'll hit the shoulders. I use 22g, 1.5 inch. I've injected ref-b in my bicepts b4 but not fina. It was kinda weird b/c at first the pain would be really intense and they would be sore for a couple days, but then the pain would be less and less with each injection.

 

[HUCKLEBERRY FINNaplex]

I rotate between the quads and delts,and I prefer a 25 guage 1".

 

[tri~zilla]

well....here is what i was doing.... today will be my last day on tren
...i use 25gauge 1 inch needles and rotated bis/delts/calves/traps

no problem what so ever now......i just started using ip suspension/prop mix.... i did left trap last night, hurt so bad it was hard to sleep....had to take some tylenol.....but the homemade tren i used was painless......have fun

 

[drrman]

i usually do all delts and tricep injections using a 25g 1" pin, i definitely think the site injects have helped my delts

 

[tri~zilla]

i agree with drr.....my side delts are standing way out and my peaks on my bis are better....maybe it's only temporary but it looks nice.....and i haven't done delts in 2 weeks, been skipping them because they got a little sensitive.....still popping out so far!!!

 

[rodd45]

I found it to be a pain but I rotated shoulders, bis, glutes, and quads. The only ones that bothered me were the bi shots. I used a 25 g 1 " pin for delts and bis and 1.5 " for quads and glutes.

 

[Wombat]

shoulders --bis--and tris with a 25G --1 inch(every day)

 

[FatChops]

25g 1". I rotated from quads to delts and sometimes i would shoot bi's and tri's. They were painless for me but a little sore on the bi. Have fun

 

[FLmuscles]

I've been experimenting with site injections with Tren on this cycle, doing almost all of my shots in my bi's, with a 27g 5/8" needle, as I want these fucking guns BIGGER! It's slow to go into this needle, but it does go in. I also use 25g 1" needles sometimes, in the quads, but most of my shots have been in the bi's, rotating upper-mid-lower, inner and outer bi's. SO far, they've gone from 18 1/2 to 19 1/2 on this cycle, but some of that might be the oil in there too--I'm hoping to hit 20", dammit!

I'm trainnig bi's tomorrow. Can't wait!

 

[gilly6993]

Quads, side delts, rear delts, front delts, tris, and calves.....

 

[Wombat]

I've been experimenting with site injections with Tren on this cycle, doing almost all of my shots in my bi's, with a 27g 5/8" needle, as I want these fucking guns BIGGER! It's slow to go into this needle, but it does go in. I also use 25g 1" needles sometimes, in the quads, but most of my shots have been in the bi's, rotating upper-mid-lower, inner and outer bi's. SO far, they've gone from 18 1/2 to 19 1/2 on this cycle, but some of that might be the oil in there too--I'm hoping to hit 20", dammit!

I'm trainnig bi's tomorrow. Can't wait!

grab yourself an 18 G pin to load ALL your shots with---then when loaded take it off and switch to your 27G--shots that take 5 to 10 min.(just to load) are now done in 45 seconds...

 

[FLmuscles]

grab yourself an 18 G pin to load ALL your shots with---then when loaded take it off and switch to your 27G--shots that take 5 to 10 min.(just to load) are now done in 45 seconds...

DUH UHH!! I never thought of doing that. Thanks!