Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Severe Injection Site Pain

bigb797977

New member
I just started a 12 week dbol/deca/test-e cycle.

wks 1-12
Deca 400mg / wk
Test-E 750 / wk

wks 1-4
Dbol 40mg / day

I am doing twice a week injections and did the first one last night. I have never been so sore as I am today. I have run this same cycle before (different brand) and even a prop/tren-ace cycle and no where near this amount of pain. I can hardly walk or sit. The injections are 2.3ml: (0.8ml(200mg) Deca + 1.5ml(375mg) Test-E). I have done 2ml+ injections before but this is insane. I think an abscess/infection would take longer than 12 hours to set it.
 
I just started a 12 week dbol/deca/test-e cycle.

wks 1-12
Deca 400mg / wk
Test-E 750 / wk

wks 1-4
Dbol 40mg / day

I am doing twice a week injections and did the first one last night. I have never been so sore as I am today. I have run this same cycle before (different brand) and even a prop/tren-ace cycle and no where near this amount of pain. I can hardly walk or sit. The injections are 2.3ml: (0.8ml(200mg) Deca + 1.5ml(375mg) Test-E). I have done 2ml+ injections before but this is insane. I think an abscess/infection would take longer than 12 hours to set it.

Don't be apoosie my ngr... What u fail to see is its not always the amount or ml's u pin but more or less the mg's! U might have pinned 2 ml's but u actually pushed 575 mg's in 1 location. That's gonna be painful for a bit while it's absorbing! Deca is painful anyways for most people! U should try warming the oils on ur next pin and shoot em in the quads or delts so u don't have to worry about sitting on it all day!
 
If it were an abscess then it would have a head on it, be getting hard, red and hot to touch... But if it is hard and red and hot that is typical irritation as well for such a high dose in 1 spot so don't freak out! Staph and such kicks in ASAP so if u wake up tomorrow and it's spreading severely then hobble ur ass to an ER. I wouldn't sweat it tho. If u have more concerns PM me... I've been thru that chit a lot and would like to see an update and make sure u come out ok.
 
Warm it and shoot delts I tried it and havnt had pain since.

Sent from my SCH-I500 using EliteFitness
 
Since you're already sore here's what I do. My Test Prop hurts like a bitch.

Make sure you massage the area after injecting. Shortly after, massage the whole muscle with heat cream, then stretch it out slowly, then ice it for 10-15 minutes. Significant reduction in both swelling and pain.

Repeat as necessary.

With every shot it gets better though. I think my body is getting used to it now.
 
Since you're already sore here's what I do. My Test Prop hurts like a bitch.

Make sure you massage the area after injecting. Shortly after, massage the whole muscle with heat cream, then stretch it out slowly, then ice it for 10-15 minutes. Significant reduction in both swelling and pain.

Repeat as necessary.

With every shot it gets better though. I think my body is getting used to it now.

Yeah, I did prop/tren last spring and I have always heard about how prop is the most painful, but I guess I got some good shit because it wasn't nearly this bad. I am sitting at my desk with a hand warmer in my back pocket and it seems to be helping. I have done the massage and heat thing before when i used sust but I have never had this response to deca/test-e before so I didn't bother with it.
 
Yeah, I did prop/tren last spring and I have always heard about how prop is the most painful, but I guess I got some good shit because it wasn't nearly this bad. I am sitting at my desk with a hand warmer in my back pocket and it seems to be helping. I have done the massage and heat thing before when i used sust but I have never had this response to deca/test-e before so I didn't bother with it.

Trust me bro! Prop is all I use an I have never had a problem with it like I hear everyone explain. IMO its the Deca that's irritating u. It always did me and everyone else. But again I gotta stress to u that it's the mg's that cause the pain not necessarily the ml's. Pin the next in the quads and warm the syringe first. Make sure that u push in about 1/4-1/2 ml slowly then wait a few minutes until u notice the lump subside. Then push in another 1/2ml and wait. The slower the inject the better it gets. I pin about 3 ml's in my quad at once and it takes me about 5-10 mins from start to finish and I don't have no issues at all! Try that in the quads!!! At least if it does continue to get sore it's easier to massage and u won't have to sit on it all damn day!
 
Ive been dealing with some insane injection site pain with my new test prop. One was so bad I actually went to the doctor figuring it was an abcess, it wasnt .

Anyways I have tried a couple of things and the only one that really worked, was heating it up. Nothing else worked. I cut it with B12, cut with more oil...nothing. Now I heat it and inject it warm...goes in nice, no pain afterwards. Hope it works for you too!
 
Trust me bro! Prop is all I use an I have never had a problem with it like I hear everyone explain. IMO its the Deca that's irritating u. It always did me and everyone else. But again I gotta stress to u that it's the mg's that cause the pain not necessarily the ml's. Pin the next in the quads and warm the syringe first. Make sure that u push in about 1/4-1/2 ml slowly then wait a few minutes until u notice the lump subside. Then push in another 1/2ml and wait. The slower the inject the better it gets. I pin about 3 ml's in my quad at once and it takes me about 5-10 mins from start to finish and I don't have no issues at all! Try that in the quads!!! At least if it does continue to get sore it's easier to massage and u won't have to sit on it all damn day!

My usual rotation is glutes and quads. My wife does my glutes for me and she seemed to dump it pretty quick for 2.3mls. I think it had more to do with the speed she went I usually barely put just enough pressure to move the plunger. If Im running EOD then I'll put my delts in the rotation. I know its got more to so with the mgs. I always laugh when i see ug labs put out something like a 7000mg/ml UltraMegaSuperBigAss Test blend.
 
Tried it in my quad this morning and warmed it. I injected really slow. It's a little sore now but we will see by tonight if the heating and slowing down the injection helped.
 
Tried it in my quad this morning and warmed it. I injected really slow. It's a little sore now but we will see by tonight if the heating and slowing down the injection helped.

I bet it does! Can't guarantee it bc maybe the gear u have is over dosed or has a high BA content. Anything is possible tho.
 
Turns out it's a bad batch several customers are complaining about the same issue with the test-e. Hopefully we can get the bullshit replaced with some good stuff.
 
Top Bottom