sachet transfer question

[eastcoastplayer]

what would you guys recommend to store your compounds in after you transfer from sachet packs. i was told to transfer to a 5cc syringe and store that way. there is no way i could inject accurate amnts (self glute inj.)
i am planning to transfer to sterile vials. should i pump air from the syringe into the vial first, or vise versa to make sure it goes in easily? is that an issue?
thanks for the advice and k to ya

 

[mikefear]

dont pump air into the vial.. it'll make it squirt out..did for me at least when i did my hcg mix

 

[CO B-man]

what would you guys recommend to store your compounds in after you transfer from sachet packs. i was told to transfer to a 5cc syringe and store that way. there is no way i could inject accurate amnts (self glute inj.)
i am planning to transfer to sterile vials. should i pump air from the syringe into the vial first, or vise versa to make sure it goes in easily? is that an issue?
thanks for the advice and k to ya

You more than likely are going to have to take a little air out in to get your oil in the vial. If you can get it in without thats good to go but you will hear it pushing out air where your needle is penetrating the rubber anyway. When you put more volume of oil in your vial you are creating a pressure vessel. The only time I would worry about putting air in the vial would be if it were water based solution which would more easily spoil than an oil based solution

 

[shivastool]

I've done this...pretty easy.

Sterile vials are at 0 vacuum so you need a way to release the pressure when you fill with material (in this case AAS oil)
So:
Draw out the oil into the syringe.
Clean the rubber stopper on the sterile vial w/alch.
Put a (new) 25g pin into the vial stopper and remove the plunger and tube, so you only have the actual pin sticking out (this is your release "valve")
Poke your loaded (w/sachet oil) syringe into the vial and inject the material in.
Don't go too fast as you want to give the air time to release.

When you've finished filling the vial, remove the pin.

Tada.

 

[drrman]

all you have to do is vent the vial with another pin guys, its not rocket science

 

[mikefear]

it's vial science

 

[Twoguns]

Leave in sachet and preload 1cc in a bunch of syringes using eighteen guage, then plug on your 23g and treat them as redi jects. That is what I did and it is working out great. Damn those sachets suck.

 

[gladiator2]

Yea just vent the vial with another pin,What you got in that sachet? I got some test e and its very painful.Added some extra oil to the vial to help cut the pain .

 

[eastcoastplayer]

Yea just vent the vial with another pin,What you got in that sachet? I got some test e and its very painful.Added some extra oil to the vial to help cut the pain .

next cycle
primo, var, test e. got some lsp primo and stealth, test e also stealth

thanks and k to all

 

[bighippie11]

Leave in sachet and preload 1cc in a bunch of syringes using eighteen guage, then plug on your 23g and treat them as redi jects. That is what I did and it is working out great. Damn those sachets suck.

simplest way i think^

 

[dsh89]

Vent it with another needle. I think the general consensus is in.