proper baking..

[Virtuoso]

so the cooper pharm gear my buddy got may not be scammed bc he got it 5 months ago.. id like to sterilze it first before injecting..

can you guys tell me proper baking time/temp for test e 350mg/ml?

 

[todoveritas]

Oven temperature via thermometer at 250 Farenheit. Place needle into each vial to vent. (IF you bake > 250F, the plastic may melt). 20 minutes should do the trick.

 

[Virtuoso]

okay i put the oven at 305 (before i saw your post) and pinned in a 18 gauge... within 5 minutes the oil started seeping up through the pin! is this proof that its bunk gear? i wouldnt think the enan would do that...

 

[mattdan]

okay i put the oven at 305 (before i saw your post) and pinned in a 18 gauge... within 5 minutes the oil started seeping up through the pin! is this proof that its bunk gear? i wouldnt think the enan would do that...

No, it means you over heated it.

 

[todoveritas]

Agree with mattdan above, V. Also, use a smaller guage needle and push it down only far enough to vent (do not let needle tip enter the oil).

 

[mattdan]

I think 250 is on the high side. 210 is more reasonable.

 

[todoveritas]

You are probably right, md. I like to use 250F to approx the 212F of boiling H20.

 

[H_T_]

250/275 is cool. most of the time, you don't even need it, although i still do it myself....