Primo pin size?

[Dooley]

I just did a search and found that pretty small pins work fine for primo. I was gonna use GetPinz and use their 25g 1" pins. However, they all use 3cc syringes. Is there a place I can get anything equal to or slightly smaller than 25g but with a smaller volume syringe?

 

[ace6921]

I just did a search and found that pretty small pins work fine for primo. I was gonna use GetPinz and use their 25g 1" pins. However, they all use 3cc syringes. Is there a place I can get anything equal to or slightly smaller than 25g but with a smaller volume syringe?

Small pins really don't work fine with Primo. Primo. is very thick and difficult to draw from the amp. Personally I use 23g, 1 1/2" pins. It's still hard to draw with 23g. I also personally think 1" is too short, but that is definitely just my opinion. Why does a 3cc capacity pin bother you out of curiousity? You don't have to fill it all the way up obviously.

Anyway, just my $.02.

 

[manny78]

Last time I used a 21g 1 1/2". Hurt a bit but so fast (took like 2 seconds)

 

[satchboogie]

23 gauge is ideal.. 1.25 inches is my size.

 

[babbabuee]

I use an 18g to draw up the primo and then I use the following to shoot:

25g 1" for quads
23g 1.5" glutes
25g 5/8" shoulders

25g is a bit slow injecting, but it starts to hurt if I push it in too fast anyway.

 

[babbabuee]

satch bro,
where you getting 23g 1.25" pins? i couldn't find them on getpinz(maybe I was looking in the wrong area)

 

[Big BX]

I use an 18g to draw up the primo and then I use the following to shoot:

25g 1" for quads
23g 1.5" glutes
25g 5/8" shoulders

25g is a bit slow injecting, but it starts to hurt if I push it in too fast anyway.

 

[nsashbl01]

I used 22ga 1.5" for glutes, 1" for quads, and 3/4" for Bi's and delts. I'm guessing 25ga would take a while to inject. If I push to hard my hands shake, so I would only used 22 or 23ga.

 

[C-Rock455]

you don't have to fill the shringe all the way up. and why are you only taking 100mgs or 1ml of primo anyway?

 

[Dooley]

I was just curious about the cc size because I've read that the smaller the volume of the syringe, the less pressue necessary to force the liquid through the pin. That was just one opinion though, so who knows if it's accurate.

I've used the 23g 1.5" pins for an all test cycle, and if I remember right.. they aren't too terrible. I was "hoping" I could get away with a smaller pin size, but if it takes forever to go through.. I'll go with the easier route.

Also.. I'll be taking 300mg's/week. I havn't really decided yet if I want to inj. 3x's per week, or if I should do 200mg's one day, and then 100 mg's another day.

Thanks for the help guys!

 

[babbabuee]

bump it up to 400mg per week and do two 200mg injects.

 

[Dooley]

heh.. people keep telling me to up it and then lower it. I was originally gonna do 400 and got convinced to lower it to 300. Wish I knew how I react to it so I could gauge it for myself.