Please Scroll Down to See Forums Below
Primo pain?
- Thread starter krishna
- Start date
solidspine
New member
No, it should not hurt, ask your source ---- what is the deal, how did he make it,
T-300, T-400, T-450 hurt
Suspension & Prop Hurt
Sometimes test can be baked, don’t know about other gear,
Have done Sherring Primo, and it does not hurt. Best cutting gear around.
T-300, T-400, T-450 hurt
Suspension & Prop Hurt
Sometimes test can be baked, don’t know about other gear,
Have done Sherring Primo, and it does not hurt. Best cutting gear around.
Stryker1992
Well-known member
krishna said:
Bro, i did primo at that concentration from another source, yes it does hurt that bad at 200 mg/ml. I stopped and have 20 mg's of the shit left b/c I refuse to use it the pain was so bad.
P
palehorse51
Guest
Thats why most primo is 100mg/ml. 200mg/ml is a high concentration for primo. Baking it would get rid of some of the ba, but the concentration will still be high. Withdraw it into the same syringe as some other gear you are injecting to dilute. OR Cut it with some ethyl oleate or sterile oil.
gymratforlife
Banned
How do you guys rate primo to Tren for cutting?Its one of the aas that I have never tried yet.
Just use 0.5ml at a time for 100mg per inject. If you do this every day stacked with other compounds, you can get 700mg a week and still get a very good response from the primo by relying on synergy created from multi compounds. This will prolly reduce much of the pain. Good luck.......gautho!
macrophage69alpha
New member
high mg gear typically means high amounts of solubilizing agent which tend to be irritating
gymratforlife
Banned
Nah I dont get any of those sides from tren really and I have done probably over 300 mls of it over the past few years.What I dont like is coming off it wich is always shitty for recovery.I would like to know on the primo though wich I have never tried,how good is it compared to tren for cutting.If I had to choose a single steroid to look the most muscular that I possibly could out of all the ones I have used I would say tren.georgie24 said:
Vascular Freak
New member
krishna said:
haha, yes bro.... remember I told you to inject as much as you can tolerate (meaning pain). After a while it affects your workouts and you may cut it back.
This is the only downside to UG primo. Although, many do prep it at 100 mg/ml. 200/ml would be like re-inventing the wheel if it didnt hurt. You could run well over a gram a week.
krishna, sorry to hear about the situation. I think you would have really loved primo at a gram a week. EQ should be a pretty decent substitute though.
Gymrat, primo is good stuff, but it is one of those things you need a lot of to get results. It's pretty much side effect free, although some complain of hair loss. Even my UG sources of primo are priced through the roof, so I just stick with tren as my mainstay for cutting. It's simply the best. Others who can not tolerate it usually are forced to spend a little extra and shoot 800+ mg of primo. Primo is definitely the most mild cutting steroid. It will actually build muscle on calorie restricted diets.
If tren works for you and you can handle the sides, just stick with it. If you really wanna go nuts, you could stack primo with tren and test. It's just an obscene volume of gear and you'd be a pin cushion for a long cycle. On the other hand, many argue against stacking primo and tren because tren overpowers the primo, so you're better off using one or the other.
Bottom line, IMO, stick with fina. It's the best gear, hands down. I suffer through the sides because it gives me such great results. That being said, if I were lost on an island somewhere and only had one type of gear to choose from for the rest of my life, it'd be primo.
krishna, sorry to hear about the situation. I think you would have really loved primo at a gram a week. EQ should be a pretty decent substitute though.
Gymrat, primo is good stuff, but it is one of those things you need a lot of to get results. It's pretty much side effect free, although some complain of hair loss. Even my UG sources of primo are priced through the roof, so I just stick with tren as my mainstay for cutting. It's simply the best. Others who can not tolerate it usually are forced to spend a little extra and shoot 800+ mg of primo. Primo is definitely the most mild cutting steroid. It will actually build muscle on calorie restricted diets.
If tren works for you and you can handle the sides, just stick with it. If you really wanna go nuts, you could stack primo with tren and test. It's just an obscene volume of gear and you'd be a pin cushion for a long cycle. On the other hand, many argue against stacking primo and tren because tren overpowers the primo, so you're better off using one or the other.
Bottom line, IMO, stick with fina. It's the best gear, hands down. I suffer through the sides because it gives me such great results. That being said, if I were lost on an island somewhere and only had one type of gear to choose from for the rest of my life, it'd be primo.
Vascular Freak
New member
krishna said:
Krish the eq 400 is painless. I was mixing .75 cc of eq400 with 1.5cc primo e3d and the shots weren't too bad. I wasn't until I dropped the eq that the primo got painful.
Even worse, I attempted to finish with prop 100mg eod mixed with 1 cc primo 200mg/ml concentration. It was literally the worst shot I have ever taken. It took 2 full weeks too be able to function normally again. I couldn't even sleep without taking 4-600mg advil PM's. I took two shots of that mix and said screw this, so I started pct and will rethink my gear choices for next time. I love primo but I am done with it because of that reason.
I would stick with eq, cheaper, smoother, better gains, and you can acutally walk while taking it.
beachstud
New member
I'm on my 8th week of ProForm Equipose 400mg/ml. I've been doing 1cc Eq400 along with 1cc of Test-E250 2x per week. Absolutely NO PAIN at all. I completely forget which ass cheek I put it in the very next day. I even got the nerve to try delts, and I'm thinking someday I'll even try quads again! (a nasty quad shot with T-400 had me limping like captain hook).
It's so painless I have to look at my log to make sure I rotate sites. Highly recommend Eq and ProForm, although Eq took about 6-7 weeks to kick in.
It's so painless I have to look at my log to make sure I rotate sites. Highly recommend Eq and ProForm, although Eq took about 6-7 weeks to kick in.
black sheep
Banned
This is where EO comes into play - Higher concentrations can be made with low BA content. I have used 200mg/ml Primo from my favorite Mexican lab with no pain.
P
palehorse51
Guest
Bro, I thought you were runnin other gear as well. why not try pulling it into the same syringe with something else to dilute it. worth a try before giving up on the primo.krishna said:
krishna
New member
Vascular Freak said:
I hear ya bro. And for the record palehorse, I did try to cut it with test e 250 and that shot hurt worse than primo by itself. These last few days have been hell!!! Both sides of my hips are fucked up. It hurts to stand, hurts to walk, hurts to sit, hurts to lay down.....everything fucking hurts! I'm done with primo...period. Primo 200 sucks!
beachstud
New member
krishna said:
Been there with 1cc of T-400 in the quad. I too had to make up a story to the gf and coworkers about how I fell on the corner of my coffee table in my house??? I know, stupid story, but I had to come up with something.
Go with Eq. Similar style of aas but a fraction of the cost and none of the pain.
jerichohill
New member
I think it just depends on the gear itself and how its made. I've had 100mg/ml Primo hurt just as bad as 200mg/ml Primo from another lab.
used2juice
New member
Some people just hate primo. I loved CL's 20mg/ml primo, got zero pain with it. Although I like eq a lot better too. 
used2juice
New member
DBBT said:
Shows what you know, it was 28mg weekly. It put some good size on my 96lb frame.
And it was 200mg/ml Krishna, I used it last winter.
used2juice
New member
I wouldn't bake it dude, all that will do is get rid of some of the ba and bb. And if there isn't a lot in there, then you are askin for more pain.
Maybe try heating the syringe under hot water after the oil is in it, that always helped me.
Maybe try heating the syringe under hot water after the oil is in it, that always helped me.
