pin size for stanol v

[snaplink175]

what pin size would be the best for this winny?
i plan on using 25g and using it for site injections but if ya'll used smaller with good results with that winny let me know. i am going to use site injections this time i didn't react well with drinking it.
thanks for your .02

 

[Nimrod25]

25g with Stanol-v!!! Good Luck. I have been using a 23g and am having injection problems. The damn solution keeps gettin stuck in the pin once im injecting.

 

[snaplink175]

no s**t,!!!
thanks

 

[NinjaX]

yeah stanol v is some thick shit

 

[conan69]

ahhh non micronized winny...gotta love it
it because it is water based, test suspension sucks to inject as well

unless you get the micronized form of either one

 

[Gorilla68]

Hey guys let me help you with your problem on pin size w/ stanol-v. After you draw up the solution in you needle, then you should suck up just enough oil after that to luberacate the needle so clogging is less frequent. Try it guys, it stops clogging by 80%. But you need only very little oil in the needle, just enough so it fills up only the needle part and not into the actual syringe.

 

[superstar2k5]

what oil do you use to lubricate the needle with?

 

[colosus88]

Can't just drink the Winny?

 

[da big thinker]

23g 1" works great!!!

 

[MaxBiceps]

what oil do you use to lubricate the needle with?

Oil from an oil based steroid like eq, deca, sus, etc.

 

[MaxBiceps]

ahhh non micronized winny...gotta love it
it because it is water based, test suspension sucks to inject as well

unless you get the micronized form of either one

Ttokkyo Stanol-V IS micronized. That's why it doesn't separate.
It's just so thick cause it's 100 mgs/ml instead of the usual 50
mg/ml