need a little hgh information?

[thefullstacker]

ok i posted in an old thread and was suggested to quit bumping it...so here i am

Ok my origional question was: I ordered u-100 .3ml/8mm needles. I got a bit anxious and forgot about the mixing needles... I also have glotropin 8iu bottles. it came with 10ml of Sterile water...

this is what i did. I took .8ml's of the "sterile water" and did the slow injection into the powder 8iu bottle. I then slowly mixed it till it was clear. I dont feel I need to use Bac/water since my bottles will be used in 3-4 days anyhow.

After the 3+hrs i read about how much u need to mix this. This would make a 10unit mark on my .3ml needles 1-IU correct? Is it bad that i just used the same needle and drew 3 times from sterile water in order to get the proper amount?

I ordered mixing needles today so i now will have 1ml/1/2inch needles now to mix with. I just want to make sure i didn't really do anything wrong.

I'm a first time user so the dosage is starting out small just with 1IU for a week then ill slowly progress up. I was vastly confused by the whole process but I am starting to get more comfortable with it. So i just want to make sure i'm doing it all correctly.

Last thing. Being i'm a first timer. I did'nt even feel the injection (yes i was extremely sterile). However today its slightly tender no bruising or red marks any thing like that just tender. Is this a norm or something I should be concerned with?

 

[rage22]

Expect to be a little sore after every injection. Nothing to worry about unless it gets infected but you'll be able to tell the difference. Rotate sites and get used to it because you'll be injecting 2x Ed if you go over 4iu.

You can start at 2iu Ed for 4-5 weeks and then bump it to 4.5-5iu for a few etc etc. there's a layout online somewhere just do a little digging.

You fine using the same needle to mix the water and hgh in the vial/s
Just wipe all the tops with alc wipes and let dry first. Then mix. But don't use the same needle to draw, inject and then draw and inject again. This is just retarded.

You mixing to me seems off. Recheck your math. .8ml into and 8iu bottle would be .1ml=1iu

Am I crazy or does that make sense?

 

[thefullstacker]

ok so being that i used the little needle its not a big deal instead of the bigger mixing needle? it only matters for this first bottle anyway since the mixers are in the mail!

Thanks for getting back to me i'll track that info down.

 

[rage22]

I modified my prior post. Also take a look at my thread about hgh induced gyno. It just happened to my friend. Take it slowly when you up the dose!

He jump from 2iu to 5iu in 4 weeks. That's not what you want to do

 

[thefullstacker]

that mixing is correct i may have said it funny but it took me 3hrs to have the confidence i had it correct and actually did it. I will take a look at that post now

 

[goin on 4T]

See in red

ok i posted in an old thread and was suggested to quit bumping it...so here i am

Ok my origional question was: I ordered u-100 .3ml/8mm needles. I got a bit anxious and forgot about the mixing needles... I also have glotropin 8iu bottles. it came with 10ml of Sterile water...
Throw away the sterile water and get back water. The ph of sterile water will compromise your GH in 48 hours or less.
this is what i did. I took .8ml's of the "sterile water" and did the slow injection into the powder 8iu bottle. I then slowly mixed it till it was clear. I dont feel I need to use Bac/water since my bottles will be used in 3-4 days anyhow.
Your call 2 days is the max.
After the 3+hrs i read about how much u need to mix this. This would make a 10unit mark on my .3ml needles 1-IU correct? Is it bad that i just used the same needle and drew 3 times from sterile water in order to get the proper amount?
I would just wait until you get 1ml syringe and you can use that to inject to so you don't waste a bunch of pins.
I ordered mixing needles today so i now will have 1ml/1/2inch needles now to mix with. I just want to make sure i didn't really do anything wrong.

I'm a first time user so the dosage is starting out small just with 1IU for a week then ill slowly progress up. I was vastly confused by the whole process but I am starting to get more comfortable with it. So i just want to make sure i'm doing it all correctly.

Last thing. Being i'm a first timer. I did'nt even feel the injection (yes i was extremely sterile). However today its slightly tender no bruising or red marks any thing like that just tender. Is this a norm or something I should be concerned with?

If you get red itchy patches its just a poor quality GH. I hate that!
Good luck to you.

 

[thefullstacker]

thanks guys yeah deff. going to get bac water then along with wait till the mixer needs come in!