Liquidex dosing

[MaxBiceps]

If you wanted to measure out .5 mgs of 4mg/ml liquidex, how would you go about doing so? I read WCP's post, but that will measure ~4 and ~2 mgs respectively. I was thinking if anyone knows how to get an accurate measrement of l-dex??

 

[MaxBiceps]

Also, i wass just thinking of maybe using a capillary tube like they use when drawing blood?? Maybe a 1/8th or 1/4 ml tube??

 

[JG1]

I believe using an 18g pin, .5mg Liquidex would equal about 6-7 drops....using slow steady pressure on the sryinge.

 

[MaxBiceps]

6-7 drops? Thanks bro, karma for you . I've been using 5 drops eod for the past week or so and i must say the liquid is amazing! I'm just worried I'm using more than I have to...

 

[JG1]

6-7 drops? Thanks bro, karma for you . I've been using 5 drops eod for the past week or so and i must say the liquid is amazing! I'm just worried I'm using more than I have to...

Are you taking it by itself, or are you on AS right now?

 

[Axe]

I have just started using it as well. I have been doing 1/4 cc eod (1mg). Since you are worried about taking too much and want to use 1/8 why not draw out 1/4 and use half, keep the rest in the pin and then use the other half on your next doseage. That way you will get the right ammount even though the individual doseages may be off by a drop or so.

 

[MaxBiceps]

I was taking it for the last few days of my dbol bridge, and I'm using it now in conjuction with clomid.

 

[MaxBiceps]

I have just started using it as well. I have been doing 1/4 cc eod (1mg). Since you are worried about taking too much and want to use 1/8 why not draw out 1/4 and use half, keep the rest in the pin and then use the other half on your next doseage. That way you will get the right ammount even though the individual doseages may be off by a drop or so.

thanks for the reply bro, karma. Using a sryinge to measure small amounts of liquid is not a great idea becuse some of the stuff gets trapped in the hub. What is in the hub alone may be 1/8th ml....one whole dose!!

 

[Axe]

I have a question for you. I use a 22 gauce 3/4 inch pin. Draw in 1/4 cc. Pull in a bunch of air, remove the needle and squirt that shit in along with the air. I think I get all of it out. Do you think I am still leaving a significant amount in there?

 

[mvmaxx]

I have a question for you. I use a 22 gauce 3/4 inch pin. Draw in 1/4 cc. Pull in a bunch of air, remove the needle and squirt that shit in along with the air. I think I get all of it out. Do you think I am still leaving a significant amount in there?

That's a great idea! I get mine tomorrow....can't wait.