Injection advice

[jdvega64]

I heard that if you warm up tren and test, that this makes for an easier injection. Is their any truth to this and if so, how would one do this.

 

[Beelzebub_XVF]

that goes for any oil based gear, not just test and tren. it's mostly helpful when shooting through a smaller gauge needle, like 25G's for instance. i used to put mine on top of the coffee maker in the mornings while making morning coffee, it heated it up enough to where it slid through the syringe easier when injecting. i've also read about guys that just run it under hot water for a few minutes. both work. it's not necessary though.

 

[hawaii50]

a really good tip that i found works, is to do injects right after a shower. cuz your muscles are all warm and loose. and if you want you can also warm up your oil too. I don't feel anything shooting after a shower.

 

[jdvega64]

Thanks for all the insight guys. Hope my first injection goes good. I'll keep you posted

 

[hammertime30]

I heard that if you warm up tren and test, that this makes for an easier injection. Is their any truth to this and if so, how would one do this.

Yes heating up the oil works wonders, however only use warm water from the faucet, do not heat up the water in a microwave............

 

[Güclü_oglan]

on the amp? or on the loaded syringe?

 

[ace13]

a really good tip that i found works, is to do injects right after a shower. cuz your muscles are all warm and loose. and if you want you can also warm up your oil too. I don't feel anything shooting after a shower.

I dont think this gets said enough. I wish I had known this info long ago. The difference for me is night and day.

 

[lund]

on the amp? or on the loaded syringe?

I run the loaded syringe up the faucet.

 

[flyingjer]

i just feel up the water in my sink about half way up the bottles with hot tap water then tlet the bottles sit in there for about half hour 45 minutes

 

[riverrock]

Yes heating up the oil works wonders, however only use warm water from the faucet, do not heat up the water in a microwave............

What is sufficient temperature Hammertime30? Is it regular hot water from the tap for a 1/2 minute or so?

 

[mikebzt]

What is sufficient temperature Hammertime30? Is it regular hot water from the tap for a 1/2 minute or so?

Regular hot water from the tap is just fine. Run it for a few minutes. What I do is have it under the tap while I take a shower and once out of the shower I inject. Smooth, painless inject all the time and no knots

 

[riverrock]

Regular hot water from the tap is just fine. Run it for a few minutes. What I do is have it under the tap while I take a shower and once out of the shower I inject. Smooth, painless inject all the time and no knots

I'll try that for my upcoming cycle of test P and see how it goes.