Inject Glass?

[babbabuee]

Sometimes when I open an amp of primo, I see small pieces of glass that may fall into the oil. I am using an amp opener and it's not like a bunch of glass or anything, but imagine this happens to everyone(some may not notice it because you may not see it if you aren't looking for it). Since I use an 18g to draw, and 23g to shoot, do you think I have anything to worry about? should I use one of those syringe filters?

oh, I've shot over 35amps so far this cycle and haven't had a problem as of yet.

 

[Dr. M]

Wouldn't worry about it bab... shooting through a 23g should take care of anything that comes along with the 18g draw, and even then it would be very difficult to draw glass up into the barrel of the syringe.

That said, it really does pay to REALLY pay attention to what you're doing and make sure that you don't actually observe anything pulling into the syringe but your gear.

-M

 

[babbabuee]

thanks doc, I have been visually inspecting and will continue to do so.

 

[jubei]

Always shoot with a small pin like a 25 g that way you don't have to worry about it. Crack those fucking amps with a butter knife bro, once you start you'll throw out that amp opener.

 

[babbabuee]

jubei,
how could I use the butter knife?

 

[Mike P.T.]

Yeah actually you are injecting small glass particles. I read an article in a muscle magazine about this actually a while back.

 

[BigB_79]

It happens to me all the time. I'm sure you are injecting a few tiny glass particles, but I dont think it's a big deal.

 

[jacshelb]

That's a comforting thought.... I wish all gear came in bottles.

Using 18gauge to draw from bottle: *Poke, push, draw back, switch pins, flick, poke, aspirate, push- done. All the while your bud is still scraping away at an amp of sust with that oh-so-pleasent "fingernail-on-the-chalkboard" sound. And, the dam* cutting stone gets worn out on the opener 20 amps in....


Jacob

 

[ArizonaFeeds]

YEAH !!!!How on earth could injecting GLASS PARTICLES be bad for you? IDIOTS! If you are in doubt filter it.

 

[ArizonaFeeds]

SOME OF YOU NEED TO USE YOUR HEADS!!

THINK about it. Especially before you offer advice.

 

[Fonz]

YEAH !!!!How on earth could injecting GLASS PARTICLES be bad for you? IDIOTS! If you are in doubt filter it.

Glass is made out of sand.

Fonz

 

[babbabuee]

damn arizona, you don't need to get all angry and yell at us, hehe.
Seriously dude, I agree, we should all think, WHICH IS WHY I BROUGHT THIS UP. So am I the idiot for asking, or is about 90% of the guys on this board, who probably don't use a filter, an idiot?

 

[ArizonaFeeds]

Yeah. I apologize. Just in a bad mood then All better now.

 

[Dr. M]

Yeah. I apologize. Just in a bad mood then All better now.

No more tren... for that man.

HAHA! J/k bro.

-M

 

[JerseyDevil]

filters are very easy to get a hold of on the internet just look around... better to be safe than sorry... Ill trade you some filters for some primo amps just kidding

 

[kwik95gt3]

you can try to avoid the visible glass shards when drawing from the amp-but the problem is there are glass shards to small for you to see. You want a safe solution? figure out how many amps you have-then order some presterilzed vials from a vialsandcrimpers.com or someone-get some syringe filters,some 10cc syringes, then sit down and open the amps-draw, then filter 10ccs at a time into the new vial. just remember to use a different needle to inject the freshly filtered oil into the vial, incase the one your drawing with has glass particles in it.

 

[bigdaddyhammer]

I can't believe I never realized that I might actually be injecting glas particles in there...might explain a bit of the scar tissue build-up. It must leave more scar tissue, right?

 

[Tuck]

To get a nice clean break on your vial and minimize errant glass shards, drill a hole in a piece of wood, and insert the neck of the vial, and snap off. I've been doing that, and I get a MUCH cleaner break than I did with the amp opener. File the neck, first, though.

 

[granby140]

i use a pen cap to open my amps and i have never had a problem

 

[babbabuee]

i just did my last shot of primo two days ago, let the PCT begin!!! guess I won't have to worry about the glass for a while (next cycle is in bottles).

 

[tatertoos]

INJECTING GLASS PARTICLES IS BAD!!!!
I work at a sterile injectable processing plant. We make millions of chemo and anti-hypertensive drugs every year. Our biggest concerns are particulate of any kind entering into our products. Much care and testing is utilized to assure our products purity, safety, and effectiveness.

What do you think would happen if some of those glass particles entered your bloodstream? If they didn't cut their way out of your blood vessels on the way through, what what happen if they cut the hell out of your heart or lungs, internally.