How Long Towait Between Bulking Cycle And Cutting Cycle

[VENOM]

I'm planning to do my bulking cycle in 2 weeks...Its my first cycle..D-BOL / OMAN ....
25mgs/ dbol everyday ...1-4
500mgs/Omna week ...1-10

with my Nolv, and Clomid

Now that cycle will last for a while.. I know this wong get me all ripped but it will help me put on some nice size. Now how long will I have to wait to go on a cutting cycle..Or will it be ok to hit clen after the clomid to get cutt...Let me know what you guys think I should do..Wanna get the sweet six pack for the summer...

 

[jc21]

most people say take off as long as u are on, did that for a while and really didnt like it, so my last cycle was a ten week bulking followed by a 6 week cutting, i liked it a lot, retained all my gains from the bulking. hope that helped.

 

[VENOM]

what did your 6 week cutting cycle consist off....Should I hit something like deca with eq and watch my diet to get ripped or should I just do mad cardio and hit some clen...or maybe even ECA or hydroxycut.

 

[barnes3]

cutting cycle...

This summer I did a cycle and as soon as I got done I did clomid, t3(which I won't do again) 5 days/5 off, t4 , cardio, and watch what I ate... basically a low carb diet. I started it 3 days until my winstrol ran out.


barnes3

 

[BigRugbyMan]

here are my thoughts:

I have played around lots with cycles... Switching from bulk to cut, cut to bulk... Long time off, short time off, test bridges etc...

I find it much better to cut first then bulk... You've heard of the rebound effect... This way works best from my experience

Now you can bulk then cut... However you must be careful... B/C when you are done bulking your body will still be adjusting to the newly gained mass... Thus if you are going to do a restricted calorie diet, and/or use fat burners and cardio...I would be careful... As all 3 of those factors WILL lead to lost muscle right after you bulk... If you do use one of the three, I would wait 6 weeks and use a bridge(primo or anavar) so you can retain the gained mass...

However if you are going directly from bulking to cutting... And your cut cycle is mainly to get harder and vascular... Then dont wait at all.