How do you stop waste from pinz

[CENTURION44]

How can you get that last little bit out of the pin after you inject...theres alway that last little bit that sits there and laughs at you...come get me!!!...

 

[kbrkbr]

Draw up a little bac water before drawing up your gear.

The bac water will flush out the pin.

 

[CENTURION44]

with oil???

 

[slat1]

I just leave a little air in there. Make sure the bubble stays at the plunger and you are all set.
The amount in the pin is so minimal it doesn't make a difference though!

 

[mikebzt]

Some individuals draw up a small air bubble thus getting every last drop

 

[kbrkbr]

If you're worried about the oil, you can always draw sterile oil up first, but I honestly find that it doesn't make a difference.

THe point is to create pressure on the gear for force it all out, and bac water does that. I usually use about 1cc.