Help w/ Conversion

[MickyBlues]

Okay I tried disolving my Anavar powder today in Peg300 then added some everclear. Basically followed directions that I found on this board. However, my powder did not disolve! Can someone help. What did I do wrong? I boiled water then placed the beaker (wich contained the var powder and Peg) into the boiling water and stirred. Powder did not disolve so then I added the Everclear after I let the Peg cool thinking this would do it. Nope, so what do I do??? Can I just dump it all back into the beaker and reheat till it disolves???

 

[jagerbombme]

just cut powder into some rails and snort it up dude........



jk

 

[cornfish]

Var is probably the worst thing you will ever suspend. It also depends on the concentration you are making. I haven't gotten it to suspend in anything above 20mg before.

Your water bath will take quite a bit of time with that. I would say at least an hour. Var is really grainy so you will see it just suspended and almost floating in the PEG, but very slowly you'll see it start to go into solution. Only thing I can say is patience. That and don't try to make 80mg/ml var I guess. Oh and don't pet a burning dog

 

[X Man]

lesson learned? CAP IT

 

[MickyBlues]

Ok well I was making 20mg/ml and yes it is very grainy. Would it be ok to reheat with peg & everclear already mixed? If so, should I leave it on the stove in boiling water instead of taking it off when water comes to boil?