HCG Dilution Ratio Question...

[CLOMIDCLOWN]

KARMA TO ANY1 WHO CAN SOLVE AND MY THANKS!
I want to do 250iu HCG e3d during entire cycle and I have a empty vial and 3 amps of 5000iu = 15,000iu plus plenty of bac. water.

My question is how much additional water should be added after i dilute each amp with the supplied ml of water in order to be able to easily draw the 250iu dose im looking for?

THANKS FOR ANY REPLIES ON THIS ONE GUYS!

 

[slat1]

It depends how much water w/ solution you want to shoot.

1,500 / 250 = 60

So you will get 60 250iu's administrations out of the 1,500iu's no matter how much water you put in.
*I would just add 60 iu's of water and then administer 1iu each time.
If for some reason you want to shoot more than 1iu of solution... say 2iu's of solution. You will need to mix the powder with 120iu's of water to get your 60 doses that have 250iu's of HCG in it.
Remember... no matter how much water you add... there will always be 1,500iu's in the powder of the combined 3 kits.
**By the way. Even refridgerated I am not sure the HCG will remain stable for more that a week. I can't answer this one but hopefully someone else can.

Good Luck!

 

[kbrkbr]

It really doesn't matter how much bac water you add as long as you remember that 1/60 of that amount will give you the 250 mg you want to administer. I would add more than 60iu, though, because dealing with 1iu injections is a pain in the ass and leaves too much solution in the pin. If, for example, you added 300 iu of BW, then 5 iu would give you 250mg.

 

[eviction]

KARMA TO ANY1 WHO CAN SOLVE AND MY THANKS!
I want to do 250iu HCG e3d during entire cycle and I have a empty vial and 3 amps of 5000iu = 15,000iu plus plenty of bac. water.

My question is how much additional water should be added after i dilute each amp with the supplied ml of water in order to be able to easily draw the 250iu dose im looking for?

THANKS FOR ANY REPLIES ON THIS ONE GUYS!

once you mix HCG i dont think it stays good long enough for that to be effective. I'd say it'd probably be better to either do do 500i.u. eOd, like every 4th week of your cycle... or 1000i.u. e3d every 4th week of your cycle.

 

[eviction]

It really doesn't matter how much bac water you add as long as you remember that 1/60 of that amount will give you the 250 mg you want to administer. I would add more than 60iu, though, because dealing with 1iu injections is a pain in the ass and leaves too much solution in the pin. If, for example, you added 300 iu of BW, then 5 iu would give you 250mg.

i think you are confused.. you meant 1ml injections, not 1iu. This guy should mix it with 5ml BAC and have a 1000iu/ml ratio. he can then use a slin pin and inject 1/2cc sub-q for a 500i.u. shot, or if he goes thru with his 250iu plan, he does 1/4cc shot.

 

[eviction]

If, for example, you added 300 iu of BW, then 5 iu would give you 250mg.

OMFG.. the mad scientist was smoking a little too much crack today!

 

[eviction]

It depends how much water w/ solution you want to shoot.

1,500 / 250 = 60

So you will get 60 250iu's administrations out of the 1,500iu's no matter how much water you put in.
*I would just add 60 iu's of water and then administer 1iu each time.
If for some reason you want to shoot more than 1iu of solution... say 2iu's of solution. You will need to mix the powder with 120iu's of water to get your 60 doses that have 250iu's of HCG in it.
Remember... no matter how much water you add... there will always be 1,500iu's in the powder of the combined 3 kits.
**By the way. Even refridgerated I am not sure the HCG will remain stable for more that a week. I can't answer this one but hopefully someone else can.

Good Luck!

back to math.. you will get 6 250iu shots out of a 1500iu bottle... you will get 20 250iu shots out of a 5000iu bottle... alrite people, think before you post here.. this guy could fuck his shit up and you are writing these sloppy posts