Formation of Crystals

[corndawg]

This is a question I posted on another board. It has been the concensus that the cause of the crystalization is the ratio of mg/ml. What can I do to cause the TP to stay in solution?

"Ok, My first experiment with TP powder. I used an older 5g'n' kit. Everything went as expected during preparation. However, yesterday morning I noticed crystals forming in the bottom of the vial...reheated and they disappeared. Agian this morning it was happening agian but to a much lesser degree. Did I mess something up or is this normal??? Should I reheat again??? Any help would be appreciated. "

 

[Suspension]

I think if you heated the solution in the oven(sterilization), you wouldnt have that problem anymore?

 

[corndawg]

Did that...four times to be exact. Crystalization still occurs after solution cools to room temp.

 

[Suspension]

damn bro. cant help ya. i just made my prop and i was fine. sorry.

Just shake it up a little, reheat, and see what happens...

 

[malhavoc]

I have some tren like that, crystalizes at room temp, and when heated looks fine. My concern about heating it and then using it was that it may crystalize after I've injected. That seems like it would be really unpleasent.

 

[corndawg]

I'm not sure that it would crystalize at body temp but I don't want to risk it. It would be a pain heating it before each injection anyway. I just hope it is correctable.

 

[rugger]

I was having the same problem with home brew test e powder...until....
1) light a gas burner (bunsen, stove, propane torch),
2) IMPORTANT- insert a needle into the stopper,
3) grab the bottle by the neck with some channel locks,
4) hold the bottle over the flame and swirl, in minutes your cyrstals should dissolve completely.
The oil and bottle will be VERY HOT for several minnutes!!!

You may need to do this every few days, additionally I submerse the bottle in hot tap water prior to injection.Last resort would be to add some BA to it.

Hope it helps.
Rugger

 

[Nutzz]

I have some prop from china and its 200mg/ml. If it gets below room temp it crystalizes in the bottle. If I heat it up before I draw it up, the crystals go away. I always heat it before I inject as well and I have very little pain from my injections.

 

[corndawg]

That's good to hear!!! I guess I will have to heat it before each injection. Thanks guys.

 

[corndawg]

UP

 

[corndawg]

Up for anymore insight