Please Scroll Down to See Forums Below 
wzkid
New member
Let me tell you... I have been researching gear for a year or two but, not really reading about injecting. Figured I would wait till I was sure if I wanted to go the roid route or not.
Well I finally decided to do it and got my gear and pins.
Gear is prop and tren
Pins are 25g/3cc
Figured I would do a glute inject first time and been reading alot about proper injection instructions like injecting air into the vial and lubing the needle with a drop, etc....
Got everything out tonight and got ready. Bro when I stuck that needle into my ass I was scared to death, lol. Hand was shaking the entire time and my heart rate was probably 320.
No pain, no lump, and finally no FEAR.
I fucking loved it!
Anyway, my question is this... If trying to do ED injects of separate compounds that are in separate vials what would be the best way to get them both into a pin at the same time?
When I injected the air into the first vial the prop came out smooth as silk but, for fear of losing some or squirting some into the ace vial I didn't inject air into the ace vial before pulling back. It was harder to get out and measure correctly. By luck I ended up dead on the mark but, there has got to be a better way.
What about pulling the prop out with one pin and then removing the plunger. Using a new pin and getting the ace out and squirting it into the barrel with the prop.
Any ideas on if this would work and if someone has a better idea please share.
Well I finally decided to do it and got my gear and pins.
Gear is prop and tren
Pins are 25g/3cc
Figured I would do a glute inject first time and been reading alot about proper injection instructions like injecting air into the vial and lubing the needle with a drop, etc....
Got everything out tonight and got ready. Bro when I stuck that needle into my ass I was scared to death, lol. Hand was shaking the entire time and my heart rate was probably 320.
No pain, no lump, and finally no FEAR.
I fucking loved it!
Anyway, my question is this... If trying to do ED injects of separate compounds that are in separate vials what would be the best way to get them both into a pin at the same time?
When I injected the air into the first vial the prop came out smooth as silk but, for fear of losing some or squirting some into the ace vial I didn't inject air into the ace vial before pulling back. It was harder to get out and measure correctly. By luck I ended up dead on the mark but, there has got to be a better way.
What about pulling the prop out with one pin and then removing the plunger. Using a new pin and getting the ace out and squirting it into the barrel with the prop.
Any ideas on if this would work and if someone has a better idea please share.
