Filling Syringe and Injecting

[Not2Big1535]

Okay guys, I am starting my cycle on Monday and would like to know the basics of filling the syringe. Here is what I have and how I will be doing it, please correct me if I am wrong.

600mg/week TT Cyp
400mg/week TT EQ

Shots: Mon. and Thurs.
Amount: 1.5cc Cyp / 1cc EQ

I have 100 22G 1.5" Syringes with detachable needles. I know these come in 10ml vials. How should I go about mixing these together? I was thinking using the original needle to suck up the 1.5cc of Cyp, attaching a new needle and sucking up 1cc of EQ, then attaching yet another needle and injecting. Is this the best way to do it? Thanks, and sorry if this is a stupid question, but I want to do this the most safest and sterile way possible.

N2B

 

[TxLonghorn]

No need to change out needles to draw. You only need to change the needle because you want it sharp so it causes less pain and trauma to the tissue.

The only problem you might have is if you draw too much out of the second vial. What now?

If you wanted to be anal about it, you could use 2 syringes to draw, and then empty the contents of one into the other, and then change needles...

Whatever, this ain't rocket science.

If you are half as attentive to your diet as you seem to be with these procedures, I foresee a very pleasant and enjoyable gear-ride for you.

Good luck.

 

[willing2be-freaky]

how to...

1. cleanse top of vial with alchohol swab, if u have amps this is unnecessary
2. fill syringe with the same amount of air as solution u desire
3. push air into the vial
4. using a rotating motion pull plunger back until desired amount is reached
5. if you are mixing solutions repeat steps 2 and 3 as necessary BEFORE DRAWING UP EITHER SOLUTION!! then draw up total amnt of solution from each vial u only have to use 1 needle this way and its what we do in the hospital when we mix insulin

ps.
remember to use an airlock for all im injections

 

[basskiller]

http://www.pharmtools.com/

Empty Vials


Trace clean vials are manufactured free of volatile contaminants and are ready for use. These clear glass vials are available with a cap that has an opening for access to a Teflon/silicone septa for insertion of a syringe needle. The cap is screw-on thus alleviating the need for a crimper.

Factory precleaned meeting U.S. EPA Specifications.

3 for 10.00

 

[MaxBiceps]

Re: how to...

1. cleanse top of vial with alchohol swab, if u have amps this is unnecessary
2. fill syringe with the same amount of air as solution u desire
3. push air into the vial
4. using a rotating motion pull plunger back until desired amount is reached
5. if you are mixing solutions repeat steps 2 and 3 as necessary BEFORE DRAWING UP EITHER SOLUTION!! then draw up total amnt of solution from each vial u only have to use 1 needle this way and its what we do in the hospital when we mix insulin

ps.
remember to use an airlock for all im injections

Whats an airlock??