Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Diluting Ttokkyo Winstrol

genarr3

Plat Hero
Platinum
This may seem stupid but I have to ask. I want to dilute 100mg/ml Ttokkyo Winstrol, can I use Bacteriostatic Water on a cc for cc basis as an injectable? To be used ED?
I assume yes, but assuming can get you in trouble sometimes.

Karma for all intelligent replys.
 
My training partner did this as it{winstrol} was getting stuck in the syringe and He said he worked quite well
 
using bac water is fine, assuming its truely sterile.

hey bro try this trick i do with tt 100mg winny.

i assume your shooting oil in your cycle as well. do ed inj and just mix in a little oil. draw the oil first, then the winny into the syringe. shake the hell outa the winny first, i mean really shake it good. i draw using a 23 and shoot w/ a 25. it goes very easily, in and out. warm it before you shoot, and mix the oil and winny until its 1 color.

if it clogs while drawing, push a small amount back in and then redraw, this will unclog it.

if it clogs while shooting, pull back like your aspirating, it will unclog.

but most of the time if you follow those steps you should be able to draw and shoot very easily.
 
i shoo the winny through a 25 guage with hardly any problems, if you put oil in there the winny will sink to the bottom and once the oil goes in the it lubes the winny and it 'should' go right in, same with test suspension. but if you dont wanna use the oil get some cheap hcg and use the bacteriostatic water that comes with it, hcg is useless imo

dj
 
Thanks for the input guys. Thing is yes I'm using both EQ and Sustenon, and for a few weeks I will be able to mix the Winstrol with either of those, but for the last three weeks Winstrol will be the only thing I inject, so nothing to mix with.
 
Top Bottom