Whacked New member May 2, 2004 #1 Got some high dosed Tren Enthanate that is about as thick as molasses. What is the BEST way to "thin" this stuff to make it go thru a 25 x 1 pin? Shit's so damn thick I can barely draw it with a 20" pin........ Should I add B12/Oil/other? Please don't ask WHO made it---thanks
Got some high dosed Tren Enthanate that is about as thick as molasses. What is the BEST way to "thin" this stuff to make it go thru a 25 x 1 pin? Shit's so damn thick I can barely draw it with a 20" pin........ Should I add B12/Oil/other? Please don't ask WHO made it---thanks
G genarr3 Plat Hero Platinum May 2, 2004 #2 Add sterile oil. Do not mix with water or any water based compounds.
Whacked New member May 2, 2004 #3 I realize that oil was an option as addressed in my original post......I wondered what was the BEST option for cutting my gear thinner....making it as "thin" as possible : B12/ oil/ other? Thanks
I realize that oil was an option as addressed in my original post......I wondered what was the BEST option for cutting my gear thinner....making it as "thin" as possible : B12/ oil/ other? Thanks
Please Scroll Down to See Forums Below 
