Correct pinning

[Brapbrap07]

Back when I did my first cycle with prop after injecting I would get the gear leaking back out of thwle injection site.
Is this a common problem when injecting or was I doing something wrong.. feel free to lead me in the right direction so I'm good to go here when i give this another go around.

Sent from my SCH-I535 using EliteFitness

 

[z28blak]

It's not uncommon for some to come out depending on how fast you pull the needle out usually I wait 2-3 seconds before pulling out so that the oil has a second to move away from the injection site it has seemed to work for

 

[z28blak]

Also depends what gauge needle your using

 

[Brapbrap07]

I was using a 23-24 I believe and I'd slowly inject taking a minute or so to do it.

Sent from my SCH-I535 using EliteFitness

 

[bonacris]

When you finished pinning leave the pin in for 10 seconds. Pull out half way and leave for another 10 seconds and then pull out. A drop of gear is fuck all so dont fret the small stuff

Sent from my GT-N7100 using EliteFitness

 

[Duramax747]

After pinning go ahead and leave the needle in 10-15 seconds. Slowly remove the needle from injection site. Then immediately put finger on injection site And gently rub. Works for me every time.

 

[Essie]

I also prefer to leave it in for around 5 seconds, pull out half way and leave for 5 seconds again before removing it completely. I immediately put my fingertip over the site, but have learnt (personal experience) not to rub it or massage it, as it always seems to aggrevate the tissue and make the injection site more sore than if I just keep slight pressure on it for about 15-20 seconds after removing the needle.