Please Scroll Down to See Forums Below
How to install the app on iOS

Follow along with the video below to see how to install our site as a web app on your home screen.

Note: This feature may not be available in some browsers.

napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

converting Test Prop powder

  • Thread starter Thread starter cbeaks
  • Start date Start date
C

cbeaks

Guest
Is it safe to make test prop powder in 150mg/ml? Would you have to use more dissolving solution to break down the prop than what would come in a normal conversion kit?
 
BigAndy69 said:
Why? It will just end up hurting too much and you will want to cut it with something.

I wouldn't go over 110-120mg/ml, 3% BA, 15% BB

That's what I was wanting to know. I wasn't sure if that would be too painful or not.
 
cbeaks said:
That's what I was wanting to know. I wasn't sure if that would be too painful or not.

150mg/ml is going to hurt most people.

110-120mg/ml with low BA (<3.5%) will not hurt.

Also, Benzyl Benzoate not only helps you dissolve the raw material better, it also keeps the pain down by preventing slight crystalization of the gear at the injecting site.
 
cbeaks said:
Is it safe to make test prop powder in 150mg/ml? Would you have to use more dissolving solution to break down the prop than what would come in a normal conversion kit?

Just go with a universal powder conversion kit, it's the easiest. Most kits are tailored to general use, but for prop just make sure you don't overheat it in the baking (sterilization process)

Mr.X
 
Mr.X said:
Just go with a universal powder conversion kit, it's the easiest. Most kits are tailored to general use, but for prop just make sure you don't overheat it in the baking (sterilization process)

Mr.X

that's the kit I was going to use. Prop is so cheap that I wanted to make it in a higher concentration if possible but I will probably just end up making 100mg/ml. Do you think I will need anything else besides the universal poweder conversion kit to make prop at 100mg/ml. Should there be enough dissolving solution in that kit?
 
Top Bottom