Concentration Levels - What is to High Per ML?

[black sheep]

Here is my question. I see a few different labs doing a few different things. Fisrt I see the standard Test, Deca, EQ all at about 200-250mg/ml. Then I see another lab claiming to be able to put 4-500mg/ml. Some even claim that coumpounds can be mixed, and end up in the 4-500mg/ml range.

Can this much powder be suspended in that little oil? Are they adding so much BA to keep it suspended that the injection site pain would be greater?

I even see some single compounds out there at 400mg/ml. Now I know that the T-400 mexi shit that was around for awhile hurt like hell, and who even knows if it was 400mg/ml. So what gives?

 

[MASSIVE1000]

Plenty of ba needs to be added to suspend that many mgs....that is why it hurts of course...I have read previous threads to where people were questioning whether or not 400mgs and above can actually be suspended in 1 ml....it is just like mixing sugar in a small glass of water, only so much is going to dissolve, the rest settles at the bottom.....anyone out there know how many mgs can actually be suspended in one ml???

 

[Nytol2]

It depends on the ester as to how much can be suspended, this can be increased with high amounts of BA.

The main cause of the pain though is most likely the actual concentration of hormone per ml.

I have made high mg test enth which hurt, and 100mg prop, which didnt, using the same amount of BA and BB. So the solvents were not to blame.

400-500mg/ml can be done, but why bother, cutting down on oil volume causes more pain.

 

[drl]

up to 700mg/ml has been done w/ test enan, and nytol is right it has more to do w/ concentration of test than solvent. take test enanthate for example- anything over about 325mg/ml is going to be painful to some, and over 350mg/ml is painful to just about everyone- and the solvent content needed to keep this in solution is only 1-2% ba and 10-20%bb

 

[kahbab]

i know that t-400 hurts like a bitch but i think it's from the Ba.

 

[Mythicalbeing]

Test 300mg/ml is about right, tren I like 150mg/ml,eq 600mg/ml is VERY possible but like 300mg/ml, deca 300mg/ml...that's the basics.

 

[Zell959]

I've seen an npp/test prop product claiming 150mg npp & 150 test prop per ml. Is this possible?

 

[Nytol2]

For me anything much over 200mg/ml with Test Enth hurts.

For a totally painless jab I make it at 200mg/ml with 2% Ba and 20% BB.

I can take 2ml of this in delts or tri's with absolutly no pain the next day.