Please Scroll Down to See Forums Below
Clomid from ag guys???
- Thread starter jp123
- Start date
jp123 said:
You might be reading the label upsidedown
YGPM with research info.
thanks for your support,
J @ AG
columbia58
New member
jp123 said:
One dropper full, actually about half full is one dose, should be 30 in the bottle. I have feed my rats several of their products and i promise your rat will be satisfied too...
Snarling Force
Active member
Their products are top notch and work well on my lab rats. I've never seen my rat's PCT go over so well. They kept almost all of their gains...
theprofessor
New member
my rat had that shit spraying out his nose... it tasted so bad the first time he threw up in the back of his throat and had to swallow it back down... no jokecolumbia58 said:
doublefister
New member
I had problems with the ag-guys L-CLO (clomid). Used it about half way and then it turned hard into jello. I used a syringe to draw it out too. I know Im not the only one either so Im curious if they are aware of this problem.
theprofessor
New member
did you shake the fuck out of it everyday?doublefister said:
Clomid tends to crystalized once in a while when you start your research. This happens with temperature changes in the shipping process or at the storage location. it is a very easy fix.
http://www.ag-guys.com/store/content/faq.php#35
I see some crystallization in the bottle, what do I do?
Heat up some water in a bowl, do not let it boil just heat it up close a boil, put the bottle in for about 3-4 mins, until boil.
Then take it out with a GLOVE (don’t burn your hand). NOT a rubber glove! use a hand protecting glove. DO NOT OPEN it as it will be hot, let it cool first, once cooled, hold a cloth over it and open the bottle and stir it. Just needs some heat. Be careful when opening the bottle, the contents will be hot after the boiling. DO NOT KEEP THE BOTTLE OPEN NEAR OPEN FLAMES FOR OBVIOUS REASONS! DO NOT RECAP WHILE HOT!
*wear gogles during your research for safety!
If you have future product questions, you can email us: [email protected]
http://www.ag-guys.com/store/content/faq.php#35
I see some crystallization in the bottle, what do I do?
Heat up some water in a bowl, do not let it boil just heat it up close a boil, put the bottle in for about 3-4 mins, until boil.
Then take it out with a GLOVE (don’t burn your hand). NOT a rubber glove! use a hand protecting glove. DO NOT OPEN it as it will be hot, let it cool first, once cooled, hold a cloth over it and open the bottle and stir it. Just needs some heat. Be careful when opening the bottle, the contents will be hot after the boiling. DO NOT KEEP THE BOTTLE OPEN NEAR OPEN FLAMES FOR OBVIOUS REASONS! DO NOT RECAP WHILE HOT!
*wear gogles during your research for safety!
If you have future product questions, you can email us: [email protected]
blut wump
New member
I boiled a kettle of water and poured it into a bowl. Letting the clomid bottle sit in the hot water for a few minutes restored it to a clear, pink solution. It has since recrystalized out but popping it back into a bowl of water is easy enough.
Store your clomid bottles in an upright position to keep the crystals from forming in inconvenient places within the bottle lest you end up needing to submerge the whole thing in hot water, which might not be ideal for the squeezy part of the dropper.
Store your clomid bottles in an upright position to keep the crystals from forming in inconvenient places within the bottle lest you end up needing to submerge the whole thing in hot water, which might not be ideal for the squeezy part of the dropper.
Capacities vary slightly by manufacturer, but here is a table I found.
The more zeros = a bigger capsule.
Gelatin Capsule Information
Size..............O.A.Len.......Diameter.........Capacity *
...................(inches) ......(inches) ........(Volume in mg)
000 ...............1.029 .........0.375........... 1,370
00................. 0.917..........0.322............. 950
0 ..................0.836.......... 0.289.............760
1.................. 0.748.......... 0.261............ 540
It's not likely that you'll be able to fill them completely and cap them without loss.
It's easier to fill the larger size with liquid which is about 2/3rds of the capsule and then cap it with the small empty top.
Not all products are suitable for digestion in this way.
Is there any reason anyone knows that Liquid Clomid shouldn't be given this way?
Mike
The more zeros = a bigger capsule.
Gelatin Capsule Information
Size..............O.A.Len.......Diameter.........Capacity *
...................(inches) ......(inches) ........(Volume in mg)
000 ...............1.029 .........0.375........... 1,370
00................. 0.917..........0.322............. 950
0 ..................0.836.......... 0.289.............760
1.................. 0.748.......... 0.261............ 540
It's not likely that you'll be able to fill them completely and cap them without loss.
It's easier to fill the larger size with liquid which is about 2/3rds of the capsule and then cap it with the small empty top.
Not all products are suitable for digestion in this way.
Is there any reason anyone knows that Liquid Clomid shouldn't be given this way?
Mike
blut wump
New member
I found this table:
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=9531752551&category=19260
The table in the link goes right down to Size 5 capsules.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=9531752551&category=19260
Code:
[b]
Size 000 00 0 1
Outer Diameter (mm) 9.91 8.53 7.65 6.91
Height or Locked Length (mm) 26.14 23.30 19.40 18.00
Actual Volume (mL) 1.37 0.95 0.68 0.50
Typical Fill Weights (mg) 960 665 475 350
0.70 Powder Density[/b]The table in the link goes right down to Size 5 capsules.
Last edited:
silent eternity
New member
1/2 dropper full =50 mgs?
solidspine
New member
Why not there is noting illegal about it,
I suspect he is simply trying to help his ovaries produce eggs.
Similar threads
