Another pin question

[newpump]

Quick question for you all tonight. Do I need to use a new syringe for each injection? I will be using 2 needles per injection - 1 to draw and another new sharp one to inject - but will I need to get a new syringe for each time? If not, should I try and sterilize the syringe? This would be for tren @ EOD or ED. Thanks all!

 

[newpump]

oh almost forgot - what CC syringe do you all prefer and why?

 

[ROLGOR]

3 cc syringe, not to big not to small. get new one each time. they are cheaper than dealing with an infection.

 

[newpump]

Thanks Rolgor!!

 

[mrhamilton]

yes use a new syringe every time. But to save on needle waste, try loading a couple weeks worth in advance. that way you only have to use 1 loading needle per product for 2 weeks worth of gear. I always load up 14 shots of fina in advance and have never had a problem, except if you let the fina sit in the syringe for more than 3-4 weeks the plunger seal will leak and half of the juice ends up on the wrong side of the plunger.(fina is the only one that i have had that problem with)

good luck and use sterile supplies.

later
mrhamilton

 

[Racer-X99]

Dude, pins and barrels are the cheapest part of the cycle and yet one of the most important. Be safe. Draw with a 20g or so and switch the pin to a 23g for injection. They are very cheap and not at all worth any risk.

Go to getpinz.com and you will see what I mean. By some 20g or whatever with the 3cc barrels and then 100 or so 23g or whatever you want to use. Need I say this again. They are cheap. You are injecting into your body that is very clean. Be safe!

There is no need to preload anything. For $40 you have more pins than most will use for a cycle. Hell, I have spent more than that to make sure I keep my hair!

Just my opinion.