Please Scroll Down to See Forums Below
Anadrol Powder
- Thread starter Barak
- Start date
Nucman
New member
I found this:
I have a slight problem that I’m hoping some fellow members of the this Forum can assist with.
My good friend recently made a batch of Oxymetholone inj in oil at 50 mg/ml strength. Just for the record the “recipe” was:
5 gm oxy powder
8 % BA
15 % BB
71 ml oil
made 100 ml at 50 mg/ml.
50 mg/ml is pushing the limits of solubility for Oxymetholone but it is obviously possible as when it was brewed up and filtered it was crystal clear even an hour after it had cooled. My friend had a 1 ml shot through a 25 gauge pin with no problems whatsoever.
Fast forward 24 hrs, when my friend pulled the bottle out of the cupboard for a second shot, some of it had crashed out. It was REALLY hard to get it back into solution by applying heat in a hot water bath.
Some things my friend is considering to rectify the crashing out problem include:
1: Add more solvent. I have read in another forum that 30% solvent (ie. 10% BA and 20% BB) is required to keep the Oxy suspended.
2: Cut it to 25 mg/ml and see if that does the trick.
3: Use of PEG400 in addition to BA and oil. I am not familiar with an appropriate recipe for this stuff although I do have easy access to it.
I have a slight problem that I’m hoping some fellow members of the this Forum can assist with.
My good friend recently made a batch of Oxymetholone inj in oil at 50 mg/ml strength. Just for the record the “recipe” was:
5 gm oxy powder
8 % BA
15 % BB
71 ml oil
made 100 ml at 50 mg/ml.
50 mg/ml is pushing the limits of solubility for Oxymetholone but it is obviously possible as when it was brewed up and filtered it was crystal clear even an hour after it had cooled. My friend had a 1 ml shot through a 25 gauge pin with no problems whatsoever.
Fast forward 24 hrs, when my friend pulled the bottle out of the cupboard for a second shot, some of it had crashed out. It was REALLY hard to get it back into solution by applying heat in a hot water bath.
Some things my friend is considering to rectify the crashing out problem include:
1: Add more solvent. I have read in another forum that 30% solvent (ie. 10% BA and 20% BB) is required to keep the Oxy suspended.
2: Cut it to 25 mg/ml and see if that does the trick.
3: Use of PEG400 in addition to BA and oil. I am not familiar with an appropriate recipe for this stuff although I do have easy access to it.
Thanks Bro everything else, Anavar, D-bol etc. That I got in powder had to be put into a supsension because its is damn hard to measure in milligrams for a proper dosage. Even my reload scales won't go more than a hair under 100mg. Could you still go ahead and use an ethanol/propylene glycol supension like other powders?
Similar threads
