3V needs ur help........

[tripleV]

I have a 100 unit insulin pin and I have serostim GH. I was told by a few people that 5.5 units = 1 iu on a 100 unit insulin pin? Is this true?

Also, am I supposed to use the whole vial of water to mix with the GH in the Sero kits?

Also...how many units on an insulin pin = 10 iu's of Humalin R?


THANKS buddies..

3V

 

[Zyglamail]

Im sure the guru's will step in and set you straight, but if im not mistaken IU's are much like the concentration of AAS and will vary. With sero a 126IU kit contains 7 vials that when reconstituted totals approx 126IU. if 100 units on a slin pin is 1cc and each sero vial reconstitutes to 18IU's by adding 1cc of water that would mean the 100units on the slin pin would hold almost the whole 18IU. 100units on slin pin divid by 18 would mean that 5.5 units = 1 IU. This will not be the same for all GH makers.

 

[diamonddiceclay]

THIS IS HOW TO DO IT:1-you only want to use 1 slin needle's worth of the water that comes with the serono gh with the 6mg gh bottle-this way, you get the highest potency for your gh(the more water you use, the less potent the dose of gh will be). I use the full 6 mg bottle of gh every day split in 2 shots where each 1 is up to 40 on the needle. This is the simplest way to know what dose you are getting(although it is expensive)

 

[tripleV]

Thx Zyg......

That's what I was told by quite a few people, as well as how I figured it out on my own, but now I am confused on the insulin dosage. Everyone has said that 10units = 1iu, so is insulin and GH going to be different?

Thanks for the help

 

[Zyglamail]

so is insulin and GH going to be different?

Yes, and even different GH is measured differently. In other words, the sero 126IU kits reconstitute to appox 1ml total volume which is equal to 18IU. However, if someone were to use 2x the BAW or water, then in essence you have just lowered its concentration from 18IU per cc to 9IU per cc. Think of IU's the same you would for mg's per ML when talking about AAS. Various drugs (ie slin etc) will have different concentrations.

 

[tripleV]

thx again.....

ok, so how many units will I be doing on a 100 unit pin, if I want 10iu of slin? 100 units? or 55 units?

I hate asking dumb questions, but better safe than sorry.

 

[FISHTALES]

slin measured in units....10 units slin is 10 on the pin

gh= iu(international unit), when using a 50 unit pin=1/2 cc then serano 18mg kit=1iu=5.5 units

as long as your 100 unit pin is a 1cc pin then you will have same conversion.

1iu g=5.5
2iu g=11
3iu g=16.5
4iu g=22
5iu g=27.5
6iu g=33

some times there is more than 1cc of water so you may end up with a little extra on your last poke, this is all an approximate measure.

 

[tripleV]

thanks guys.....

I think i am all set now......

<kisses>

3V