23 1.5" or 1"?

[little chris]

Got a test and eq cycle comin up and I gotta get my pins ready. I have a thin frame 5'6 155lbs and after reading countless posts I think a 23 gauge is good but not sure on the length 1.5" or 1" (glute inj).

 

[baby_bbol]

Got a test and eq cycle comin up and I gotta get my pins ready. I have a thin frame 5'6 155lbs and after ready countless posts I think a 23 gauge is good but not sure on the length 1.5" or 1" (glute inj).

Really depends on how much body fat you store in gluteal area, which usually pretty fatty compared to other areas.

I use:

23x1.5 for glutes
25x1 for quads
25x5/8 for site inj (shoulder,delt, bi,tri...etc...)

 

[thx9000]

1.5" for glutes unless you are real lean then I guess you could go with 1"

 

[General Maximus]

I would go with the 1 1/2". As long as you get a quality needle, it doesn't matter if you go an extra 1/2". You won't even feel it.
What sucks is driving a low quality pin through scar tissue, as it feels like it is tearing through the muscle.

 

[little chris]

sounds like 1.5" then and 23 gauge is ok right?

 

[MasterChief]

Yeah go ahead. 1.5" for the glute. I would go with 22 gauge just because It takes to damn long with the 23 to get all the juice in. That is just my opinion since I hate pushing hard on the syringe.

 

[granby140]

is 25g 1 inch good for glutes?

 

[MasterChief]

I wouldnt try 25g, you will be pushing that syringe all day long to get the juice in.

If it was another bodypart, like the quads, 25g is ok, but trust me on this one, when you have a needle stuck in your glute and if you use oil based steroids, it is really difficult to inject with a 25. You will probably get a cramp just trying.

Also, unless you are really lean, you can go with the 1". For glutes the trademark is 1.5".

 

[little chris]

from what i understand 25 1" is more for inj in quads. Unless your a female or you a very little ass 1" is to short and you may get an absess if you don't plunge deep into the muscle. As for the gauge 25 at 1.5" into the glute can be done but its gonna take awhile especially when using oil. for glute inj most bros use 22 or 23 at 1.5" and a few will use 25 it just takes longer and you gotta push a little harder.

 

[shoichi]

I wouldnt try 25g, you will be pushing that syringe all day long to get the juice in.

If it was another bodypart, like the quads, 25g is ok, but trust me on this one, when you have a needle stuck in your glute and if you use oil based steroids, it is really difficult to inject with a 25. You will probably get a cramp just trying.

Also, unless you are really lean, you can go with the 1". For glutes the trademark is 1.5".

I use all 25g. It helps ease the soreness after your inject - it forces you to inject slower. It takes me about 25sec to inject one CC.

I originally used the 21g pins that came w/my redijects, and I could empty those out in about 5 seconds...not very good. I'm going to use 1.5" but only go in 1" for my glutes, and 5/8 for everything else.

 

[kingc_79]

i know most people wont but i used 23g 1" on glutes, quads, and delts, just didnt go all the way in on delts. I'm only5'8" 175lbs, round 12%bf. they worked for me .

 

[little chris]

bumpin