2 quick questions about baking tren....need quick response please

[X Man]

just got done baking tren... one of the vials i was baking when i took it out there was a little something floating in it...im almost positive it was part of the rubber stopper...

i was sterile through out the entire process of making it and before i baked it i didnt notice nething floating in it at all..

the other bottle i made was fine.

two questions:

has this happen to other people ? and is the piece floating in there mostly likely just a little piece of the rubber stopper which should cause no harm?

i baked it twice at 250 degress, keeping in mind i kept things pretty much sterile, would baking it twice kill any bacteria or basically be the finishing touch to sterilizing nething that 'squeaked through the cracks' so to speak?

 

[X Man]

bump guys

 

[X Man]

come on bros...nothing?

 

[Tryin2grow]

Where did you get your directions, where your supposed to bake it twice at 250???

 

[Mr.X]

I responded to your PM in regards to this - about 10 min ago.

 

[x_muscle]

I would filter it again, and bake it.

 

[X Man]

I responded to your PM in regards to this - about 10 min ago.

thanx a lot mr x.... i hit u back

ur da man

 

[ryan04]

When you bake tren you have to put a needle through the stopper to let evaporation and heat out...if not you might melt the stopper.

I'm assuming your talking about fina. I don't see any need to bake fina, there is so much b.a. in the kits it is already sterile. I can actually taste b.a. in my mouth about 5-10 seconds after I shoot.

 

[anal itch]

I've found that using the 18 gauge needle while filtering into the sterile vial causes some serious damage to the rubber stopper. I prefer to use a 27g pin for venting and a 22g pin for filtering into the vial.

If you used the 18g as most directions state then it's most likely rubber. To be safe, re-filter it into another vial and don't use those harpoons as directed.

 

[X Man]

I've found that using the 18 gauge needle while filtering into the sterile vial causes some serious damage to the rubber stopper. I prefer to use a 27g pin for venting and a 22g pin for filtering into the vial.

If you used the 18g as most directions state then it's most likely rubber. To be safe, re-filter it into another vial and don't use those harpoons as directed.

ahha makes sense cause i had another vile witch i used a 25 g needle and that one was fine....