Before you say anything this is how I prep for my bbing shows and I'm 246lb compete at 225lb. I'll give you my doses for cuts, and my philosophy on dieting etc
1-16 arimidex .5-1mg ed
1-16 Test P 100 mg eod
1-16 EQ - 300 mg 2x per week
3-16 clen 40-80 mcg (rotate every 2 wks)
8-16 Masteron P...
How much of these do you have?
Also you will need to buy an atomic ass inhibitor either aromasin or arimidex
Sustanon 250---1 to 2cc's a week
Masteron p100mg/ml---1to 2cc's eod
Testosterone cypionate 300mg/ml you don't need the cyp in this cycle Sustanon is enough, but when you use it it...
I'm 5'8" 246lb start weight I am now 224.6lb 6 weeks out
Cycle was...
Test e 300mg wk
Eq 800mg-1000mg wk
Tren e 200-400mg wk
Aroma 12.5mg Ed
T3 25mcg Ed
Currently my cycle looks as follows
Most are pharm grade
Test e 300mg wk split
Tren e 200mg wk split
Parabolan (Tren hex) 400mg wk...
Caber would fix a prolactin problem, Not a progesterone problem. Progesterone becomes elevated when estrogen is not in check. I would up your arimidex dose to .5 Ed, if that doesn't help add in 20mg nolvadex eod
I would ditch the ghrp-2 for ipam
Also the igf might be a little redundant seeing you are using insulin
400mcg Ipam upon waking & 5 iu of Humalog
Assuming u are running Humalog I would dose 10iu pre workout & 10iu post w/ 400mcg ipam
Take ur mod GRF before bed
Also u might want to invest...
Most use crimp tops where they crimp the top after they fill the vial. So I would assume ur screw top would be sufficient as long as it creates a solid seal. Having pressure escape would make it hard as hell to draw out of.
It depends on his genetics and the level of the show he is competing in regional vs national qualifier. Juice is a part of the sport all the teen and collegiate nationals competitors juice. Now saying all of this and he's only 20yro I would say he should build his body up naturally and juice...
I was about to say it was the tren reducing your t3 production, but since your off it might be u are suppressing ur estrogen too much with eod dosing try e3d