XBiker New member Jan 28, 2002 #3 Yep, fluid rejection. I normally leave the pin in for a good 10-15 seconds after injecting to allow the fluid to "set in" www.getpinz.com
Yep, fluid rejection. I normally leave the pin in for a good 10-15 seconds after injecting to allow the fluid to "set in" www.getpinz.com
Roadblock New member Jan 28, 2002 #4 Yeah, happened last week and freaked me out for a couple of minutes but then I got a rush and wanted to do it again I was bleeding like a stuck pig.
Yeah, happened last week and freaked me out for a couple of minutes but then I got a rush and wanted to do it again I was bleeding like a stuck pig.
M mattsofl New member Jan 28, 2002 #5 I just posted about this on another board. It has been happening to me a lot lately. It was suggested to me to inject slower. The next injection, I went very slow, and nothing came out.
I just posted about this on another board. It has been happening to me a lot lately. It was suggested to me to inject slower. The next injection, I went very slow, and nothing came out.
jc21 New member Jan 28, 2002 #6 it is normal....i just have a cotton ball ready and put it over the injection site when i am done.
B bigguns7 New member Jan 29, 2002 #8 I think it probably happens to everyone on a semi-regular basis.
G gilly6993-recreatedbygeorge Guest Jan 29, 2002 #9 It happened to me...pissed me off. I soaked it up with a tissue, wrung it out into a syringe and reinjected it. Didn't want to waste anything....
It happened to me...pissed me off. I soaked it up with a tissue, wrung it out into a syringe and reinjected it. Didn't want to waste anything....