Need A Squat Suit....

[mm107]

Im looking at the inzer single ply. Dont want double ply because i dont find them fair, but also because alot of the federations i WANT to lift in is single ply.

I just dont know whats out there either....

Can anyone give me any feedback on the inzer suit. Its the inzer Max suit. I got to order on monday as i stretched out my training suit....

Also would be nice if a suit could be used w/ the deadlift as well, but ill throw on an erector shirt under my suit for it....

Thanks all!

P.S. if anyone has a new max inzer size 33 let me know lol

[Parabellum]

Check ebay.

[Nytol2]

Quote posted by mm107 Also would be nice if a suit could be used w/ the deadlift as well, but ill throw on an erector shirt under my suit for it....

That is the 1st time I have ever heard of anyone using one of these shirts.

Most feel they are no good, have you used one before?

What is your opinion?

The BOSS is a great squat suit.

[mm107]

Quote posted by Nytol2 That is the 1st time I have ever heard of anyone using one of these shirts. Most feel they are no good, have you used one before? What is your opinion? The BOSS is a great squat suit.

i havnt used one before...but i know one problem i have when deadlifting is rounding my back because i dont keep my shoulders back. an erector shirt would force me to keep everything back and tight...

boss squat suit huh?
better then inzeR?

[brbb]

boss squat suit huh?
better then inzeR?[/quote]

The Boss suit is great but from what you said in your first post, it won't work for you as it isn't allowed in single ply feds. My .02 for what it is worth, I have used the and the Titan Dual Quad. I would go with the latter as I got a lot more pop out of it. I also used it to deadlift in (Sumo) and got some pop off the floor. Check your PM box for more info.
As for rounding your back on the deadlift, try this. Have a training partner (hopefully you have one, if not grab some schmoe for a minute) watch you setup for the deadlift from the side. Reach down and grab the bar, set up to pull with the bar right against your shins, and before you pull off the floor, have him/her keep telling you to arch until your shoulders are behind the bar. While they are yelling this you should be pulling against the bar to pull your hips down and force your back to arch. It may be awkward at first but trust me when I tell you it puts everything into the most advantageous point for leverage. Once your shoulders are behind the bar, they should yell pull and you should keep forcing the arch with your head up as you pull. Try this with some lighter weights for a while until you get the hang of it and I guarantee you will feel the difference almost immediately.

[Nytol2]

Certain singly ply feds allow the Boss, if the straps are sewn, and not velcro.

I am very new to equipped lifting but I have trained with national and european champions, and the general concensess is that Titan gear is better than most Inzer.

None of them are sponsored, so that is their honest opinion.

I have deadlifted in the Boss, conventional, and found it to be good, pulled 300kg in my 1st comp at 105kg bodyweight.

Which is not huge, but it was the 1st time I have ever DL, after doing a max squat and bench, so I was pleased.

[squirt-tribepowerlifting]

Boss is not allowed in single ply federations
The Boss material is too strong